Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 320
– Install the self-tapping bolts -2- until the thread engages.
– Tighten the bolts -2- only to the required tightening specifica‐
tion, so that they are not over tightened.
– Position the side sill trim panel -1- evenly in direction of
-a arrows- with the openings on the back over all of the screws
-2- until the side sill trim panel touches the side sill -3-.
Position the side sill trim panel with a second mechanic so that all
screws remain in the openings when molding is slid on.
– Push the side sill trim panel forward forcefully until stop in di‐
rection of -b arrows-.
– Install the exterior bolt -4- in the side sill trim panel.
Tightening Specifications
Dimensions
Note
♦
The screws for the side sill trim panel are corrosion-resistant. Additional treatment is not necessary.
♦
If a screw is overtightened, it must always be replaced with a “black” oversized screw.
– Measure the holes according to the table below.
– Punch the holes for the screws.
– Pre-drill the holes using a 1.5 mm drill.
Note
♦
Dimension -a- is measured including the front wheel housing liner. Dimensions -b through I- are always
measured from the center hole outward.
♦
Dimension -m- is only measured on a 4-door in the rear area.
♦
For a 2-door vehicle, the dimension -m- must be aligned in height according to the front holes.
Dimensions Table
Dimension -a-
= 758 mm
Dimension -b-
= 713 mm
Dimension -c-
= 593 mm
Dimension -d-
= 453 mm
Dimension -e-
= 303 mm
Dimension -f-
= 152 mm
Dimension -g-
= 1028 mm
Dimension -h-
= 906 mm
Dimension -i-
= 755 mm
Dimension -j-
= 604 mm
Dimension -k-
= 453 mm
Dimension -l-
= 302 mm
Dimension -m-
= 50 mm
3.6
Front Door B-Pillar Trim, Removing and Installing
Note
The following describes the removal and installation of the left side. Removing and installing the right side is
identical.
Removing
– Lower the door window.
– Remove the window guide -3- in the area of the B-pillar trim
-1- from the door frame in direction of -arrow-.
– Unclip the expanding rivet -2-.
– Push the B-pillar trim -1- downward and remove from the door
frame.
– Remove the B-pillar trim -1- upward.
Installing
– Position the B-pillar trim -1- on the door frame.
– Guide the B-pillar trim -1- in at the bottom and position it.
– Push the B-pillar trim -1- upward until it touches the window
guide -3-.
– Clip in the expanding rivets -2- from the top to the bottom and
insert the window guide -3- in the B-pillar trim in direction of
-arrow-.
3.7
Rear Door B-Pillar Trim, Removing and Installing
Note
The following describes the removal and installation of the left side. Removing and installing the right side is
identical.
Removing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст