Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 319
3.2
Overview - Side Sill Trim Panel
1 - Side Sill Trim Panel
❑ Removing and instal‐
ling. Refer to
.
2 - Bolt
❑ 1.2 Nm
❑ Quantity: 12
❑ Dimensions. Refer to
3 - Bolt
❑ 1.2 Nm
❑ For attaching the side
sill trim panel
❑ Quantity: 1 on side sill
3.3
Overview - Heat Shield
Note
Depending on the engine versions the heat shield and mounts may differ slightly.
1 - Floor Heat Shield
❑ Removing and instal‐
ling. Refer to
2 - Lock Washer
❑ Quantity: 6
3 - Center Exhaust System
Heat Shield
❑ Removing and instal‐
ling. Refer to
.
4 - Lock Washer
❑ Quantity: 2
5 - Rear Muffler Heat Shield
❑ Removing and instal‐
ling. Refer to
.
6 - Lock Washer
❑ Quantity: 5
3.4
Drip Rail, Removing and Installing
Note
The following describes the removal and installation of the left side. Removing and installing the right side is
identical.
Removing
– Pull the drip rail -1- starting from below from the clip -3- and
the retaining strip -2-.
Installing
– Position the upper inner drip rail edge -1- on the windshield
upper edge.
– Push the drip rail -1- from above into the retaining strip -2- and
clip -3-.
– Guide the drip rail lip for the windshield behind the glass.
3.5
Side Sill Trim Panel, Removing and Installing
Removing
– Remove the outer bolt -4- from the side sill trim panel.
– Push the side sill trim panel -1- rearward in direction of
-a arrows-, until the side sill trim panel is loosened from all
screws -2-.
– Remove the side sill trim panel -1- from the sill panel -3- in
direction of -b arrows-.
Installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст