Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 322
3.10
Center Exhaust System Heat Shield, Removing and Installing
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
Removing
– Remove the exhaust system rear section. Refer to ⇒ Rep. Gr.
26 ; Exhaust Pipes/Mufflers; Overview - Muffler .
– Loosen the lock washers -2-.
– Remove the heat shield -1-.
Installing
Install in reverse order of removal.
3.11
Rear Muffler Heat Shield, Removing
and Installing
Special tools and workshop equipment required
♦ Engine and Gearbox Jack - VAS6931-
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
Removing
– Loosen the mounts for the rear muffler and lower the rear muf‐
fler slightly using the Engine and Gearbox Jack - VAS6931- .
Refer to ⇒ Rep. Gr. 26 ; Exhaust Pipes/Mufflers; Overview -
Muffler .
– Loosen the lock washers -2-.
– Remove the heat shield -1-.
Installing
Install in reverse order of removal.
4
Noise Insulation
⇒ “4.1 Overview - Noise Insulation”, page 422
4.1
Overview - Noise Insulation
⇒ “4.1.1 Overview - Noise Insulation, Short”, page 422
⇒ “4.1.2 Overview - Noise Insulation, Long”, page 423
⇒ “4.1.3 Overview - Impact Guard”, page 424
4.1.1
Overview - Noise Insulation, Short
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
1 - Noise Insulation, Short
❑ Removing
– Remove the bolts
-2 and 3-.
– Remove the noise insu‐
lation toward the rear
from the lock carrier.
2 - Bolt
❑ 2 Nm
❑ Quantity: 3 on the left
side
❑ Quantity: 4 on the right
side
3 - Bolt
❑ 2 Nm
❑ Quantity: 1 on the lock
carrier
4.1.2
Overview - Noise Insulation, Long
Note
Depending on the engine version, slight deviations must be considered when removing and installing.
1 - Long Noise Insulation
❑ Removing
– Remove the bolts
-2, 3, and 4-.
– Remove the noise insu‐
lation toward the rear
from the lock carrier.
2 - Bolt
❑ 2 Nm
❑ Quantity: 3 on the left
side
❑ Quantity: 4 on the right
side
3 - Bolt
❑ 6 Nm
❑ Microencapsulated
❑ Replace after removing
❑ Quantity: 3
4 - Bolt
❑ 2 Nm
❑ Quantity: 1 on the lock
carrier
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст