Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 424
– Connect the Airbag Lockout Adapter - VAS6282- to the side
airbag wiring harness -1-.
Caution
The Airbag Lockout Adapter - VAS6282- must stay connected
to seat until seat is installed again.
2.13
Tunnel-Side Seat Trim, Removing and
Installing
Note
The following describes the removing and installing on the left
side of the vehicle. Removing and installing on the right side is
identical.
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Removing
– Remove the front seat. Refer to
⇒ “2.10 Front Seat, Removing and Installing”, page 335
.
– Remove the trim panel -1- expanding rivets -arrows-.
– To do so, press the clamping pins in the expanding rivets
-arrows- toward the inside.
– Pry off the expanding rivets -arrows- using the Trim Removal
Wedge - 3409- .
– Remove the trim panel -1- from the mounts in the seat frame.
Installing
Install in reverse order of removal while paying attention to the
following:
– Insert the expanding rivets -arrows- and push the pins in.
Tightening Specifications
♦ Refer to
⇒ “2.2 Overview - Front Seat”, page 318
2.14
Sill-Side Seat Trim, Removing and In‐
stalling
⇒ “2.14.1 Door Sill Side Seat Trim, Removing and Installing, Ex‐
cept Power Seat”, page 345
⇒ “2.14.2 Door Sill Side Seat Trim, Removing and Installing, Pow‐
2.14.1
Door Sill Side Seat Trim, Removing and
Installing, Except Power Seat
Note
The following describes the removing and installing on the left
side of the vehicle. Removing and installing on the right side is
identical.
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Removing
– Position the seat into its highest position.
– Remove the backrest adjuster. Refer to
⇒ “2.21.1 Backrest Adjuster, Removing and Installing, Except
.
– Remove the seat height adjustment handle. Refer to
⇒ “2.18 Seat Height Adjustment Handle, Removing and In‐
– Press the clamping pin -3- toward the inside.
– Pry off the expanding rivet -2- using the Trim Removal Wedge
- 3409- .
– Remove the bolt -arrow- from below.
– Open the bracket -4- on the trim panel -1- from below.
– Guide out the rear trim panel -1-.
– Remove the trim panel -1- forward from the bracket -5-.
Installing
Install in reverse order of removal.
Tightening Specifications
Component
Tightening Specification
Screw between bracket and
side trim panel. Refer to
2 Nm
2.14.2
Door Sill Side Seat Trim, Removing and
Installing, Power Seat
Note
The following describes the removing and installing on the left
side of the vehicle. Removing and installing on the right side is
identical.
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Removing
– Position the seat into its highest position.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст