Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 314
– Now screw an 8 mm screw (approximately 80 mm long) into
the spreader plug -4-.
Note
Do not apply excessive pressure on the plug when installing the screw into the plug. Otherwise it will fall inside
the door.
– Remove the spreader plug -3- from the window regulator guide
-2- and thereby from the door window.
– Remove the trim. Refer to
⇒ “3.7 Rear Door B-Pillar Trim, Removing and Installing”, page
.
– Remove the front part of the window guide -2- from the mount.
– Remove the door window -1- upward at an angle in direction
of -arrows- with respect to the outside of the vehicle from the
window shaft.
Installing
Note
♦
The spreader plug and expanding pin must be replaced when performing assembly work on the door window.
♦
Check the window glass -8- for damage before installing the spreader plug -3- and the expanding pin -2-.
– Install the spreader plug -3- centered with the window glass
-8- removed.
– Press in spreader pin -2- flush into spreader plug -3-.
– Install the door window -8- in the door -arrows- and push in the
window regulator guide slot.
– Using light pressure from above engage the window glass
-8- in the window regulator -1-.
Installation is performed in reverse order of the removal.
– Check the function before installing the door inner cover -7-,
and the door trim panel.
5.6
Fixed Rear Door Window, Removing and Installing
Removing
– Remove the door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel, Re‐
moving and Installing .
– Remove the outer window shaft strip. Refer to
⇒ “2.15 Outer Window Shaft Strip, Removing and Installing”,
– Remove the window guide. Refer to
⇒ “2.14 Window Guide, Removing and Installing”, page 183
.
– Lift out the caps -6-.
– Remove the screws -5-.
– Remove the seal -2- from the sheet metal flange.
– Guide the Window Release Tool - T10236- one after another
under both clips -3-.
– Push the door window -1- slightly out in direction of -arrow a-
until the clips -3- are pushed out of the door -4-.
– Remove the door window -1- with the bar -7- upward in direc‐
tion of -arrow b- from the door -4-.
Installing
– Push the door window -1- into the door in direction of
-arrow a-.
– Push the door window onto the door -5- until the clips -6- click
into place in direction of -b arrows-.
– Tighten the bolts -3-.
– Pull the seal -2- around the flange.
Installation is performed in reverse order of the removal.
Tightening Specifications
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст