Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 285
Tightening Specifications
1.14
Roof Shade Control Module - J394- , Removing and Installing
Removing
– Remove the headliner. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Roof Trim Panels; Headliner, Removing and Installing
– Disconnect the harness connector -2- from the sun shade mo‐
tor -1-.
– Remove the bolts -3-.
– Remove the sun shade motor -1-.
Installing
Install in reverse order of removal. Note the following:
– Before installing the sun shade motor, the sun shade must be
aligned to be parallel.
– Measure and adjust the distance -dimension a- between the
shade arch -1- and the shade cartridge -2-.
– After completing all work steps, perform an adaptation on the
sun shade motor. Refer to
⇒ “1.18 Roof Shade Control Module J394 , Programming”,
.
Tightening Specification
♦ Refer to
⇒ “1.2.3 Overview - Sunroof, Wagon”, page 199
1.15
Sunroof Seals, Removing and Installing
⇒ “1.15.1 Sunroof Frame Seal, Removing and Installing, Sedan”,
page 273
⇒ “1.15.2 Glass Panel Seal, Removing and Installing, Sedan”,
page 275
⇒ “1.15.3 Sunroof Frame Seal, Removing and Installing, Wagon”,
page 276
⇒ “1.15.4 Glass Panel Seal, Removing and Installing, Wagon”,
1.15.1
Sunroof Frame Seal, Removing and In‐
stalling, Sedan
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
to
Removing
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
.
– Remove the seal -1- from the sunroof frame -2-.
Installing
– Align the inner seal -1- with the vulcanized point to the curve
on the sunroof frame -3- -a arrows-.
– The sealing lip -arrow b- must be aligned outward.
– Push the inner seal -1- evenly in the sunroof frame mount
-2-.
– Install the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
.
1.15.2
Glass Panel Seal, Removing and Instal‐
ling, Sedan
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
to
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Removing
– Open the glass panel.
– Remove the seal -2- from the glass panel -1-.
Installing
– Align the seal -2- at the outer edges of the glass panel -1-
-arrows-.
– Press the seal -2- into the mount on the glass panel -1-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст