Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 286
1.15.3
Sunroof Frame Seal, Removing and In‐
stalling, Wagon
Special tools and workshop equipment required
♦ Roller - 3356-
♦ Adhesive Strip Remover - VAS6349-
Removing
– Remove the frame. Refer to
⇒ “1.4.2 Sunroof Frame, Removing and Installing, Wagon”,
– Remove the outer seal -1- with the adhesive surface -3- from
the roof -2-.
Installing
Installing
– Remove any adhesive residue with Adhesive Strip Remover -
VAS6349- .
– The adhesion surface on the roof cutout must be free of dust
and grease.
– Clean the adhesive surface thoroughly with Cleaning Solution
- D 009 401 04- .
– Wipe down the adhesive surfaces on the roof opening with the
supplied primer towel.
– Observe the drying times for the supplied primer towel.
– Center the new outer seal -1- and the joint -arrows- with re‐
spect to the center of the rear roof opening.
– Remove the protective film from the adhesive tape -3- and
press the seal onto the roof -2-.
– Press the outer seal on evenly to prevent any excess length.
– Using the Roller - 3356- , press the outer seal two times firmly
and evenly all the way around.
– Install the frame. Refer to
⇒ “1.4.2 Sunroof Frame, Removing and Installing, Wagon”,
.
1.15.4
Glass Panel Seal, Removing and Installing, Wagon
Removing
– Remove the rear glass panel. Refer to
⇒ “1.7 Rear Sunroof Panel, Removing and Installing”,
– Remove the seal in the side area -4- from the rear glass panel
-1- to the side in direction of -arrow b-.
– Remove the seal in the front area -3- from the rear glass panel
-1- in an upward direction in direction of -arrow a-.
Installing
– The seal is sprayed with a soapy water solution to facilitate
installation in the mount.
– Press the seal in the front area -3- from above into the mount
of the glass panel -1-.
– Press the seal in the side area -4- into the mount of the glass
panel -1-.
– Install the rear glass panel. Refer to
1.16
Sunroof Shade, Removing and Instal‐
ling
⇒ “1.16.1 Sunroof Shade, Removing and Installing, Sedan
through 02/2015”, page 279
⇒ “1.16.2 Sunroof Shade, Removing and Installing, Sedan from
03/2015”, page 288
⇒ “1.16.3 Sunroof Shade, Removing and Installing, Wagon”, page
1.16.1
Sunroof Shade, Removing and Instal‐
ling, Sedan through 02/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
to
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Removing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст