Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 282
WARNING
Only use the adhesive specified in the Parts Catalog, because
it is adapted for elasticity to the trim.
The minimum curing time for safe vehicle operation is three
hours.
– Lightly sand the adhesive surface with fine sandpaper.
– Thoroughly clean around the adhesive surface -2- using the
cleaning solution.
– Apply the glass/paint primer evenly in a single stroke using the
applicator.
– The drying time for the glass/paint primer is 10 minutes.
– Apply one-part adhesive -2-.
Width of the adhesive bead -2-: 8 mm.
Height of the adhesive bead -2-: 12 mm.
– Insert the trim into the roof opening and center it. Secure with
adhesive tape.
– Observe the minimum curing time. Refer to
.
1.13
Power Sunroof Control Module - J245- ,
Removing and Installing
⇒ “1.13.1 Power Sunroof Control Module J245 , Removing and
Installing, Sedan through 02/2015”, page 261
⇒ “1.13.2 Power Sunroof Control Module J245 , Removing and
Installing, Sedan from 03/2015”, page 265
⇒ “1.13.3 Power Sunroof Control Module J245 , Removing and
1.13.1
Power Sunroof Control Module - J245- ,
Removing and Installing, Sedan through
02/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
to
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Screws - Drive Motor to Panorama Sunroof
Removing
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
.
– Remove the glass panel if the drive motor is defective. Refer
to
⇒ “1.6.3 Glass Panel, Removing, Defective Drive Motor, Se‐
dan through 02/2015”, page 232
.
– Remove the self-adhesive insulation -3-.
– Remove the bolts -2-.
– Remove the cover -1- upward at an angle in direction of
-arrows-.
WARNING
Only remove and install the Panorama sunroof glass panel
drive motor when the roof is closed (neutral position).
Requirements for removing and installing the drive motor: the
engine and the ignition must be off, remove the key and open
the door.
– Turn the engine and ignition off, remove the key and open the
door.
– Remove the screws -4- and remove the Panorama sunroof
drive motor -1-.
– Disconnect the connector -5- for the drive motor.
Installing
Note
The screws for the drive motor are micro-encapsulated and must always be replaced.
– Connect the connector -5- to the drive motor -1-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст