Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 283
– Make sure that the clip -2- is in the correct position.
– Install the drive motor -1- and tighten the screws -4-.
– After installing, the key can be reinserted into the lock cylinder
of the ignition/starter switch.
– Then perform function test.
– Push the cover -1- on the sunroof frame.
– Tighten the screws -2-.
– Apply the self-adhesive insulation -3-.
– Install the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
Tightening Specifications
1.13.2
Power Sunroof Control Module - J245- ,
Removing and Installing, Sedan from
03/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
to
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Removing
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
.
– Remove the bolts -3- for the cover -1-.
– Lift up the cover -1- and remove it from the slotted guide rail
guide mounting points -2- at the rear -arrows-.
WARNING
Only remove and install the Panorama tilting sunroof glass
panel drive motor when the roof is closed (neutral position).
Requirements for removing and installing the drive motor: the
engine and the ignition must be off, remove the key and open
the door.
– Turn the engine and ignition off, remove the key and open the
door.
– Remove the bolts -2- and remove the Panorama roof tilting
sunroof drive motor -1- from the mount -4-.
– Disconnect the connector -5- for the drive motor.
Installing
Note
The bolts for the drive motor are micro-encapsulated and must always be replaced.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст