Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 985
❑ Its function is to prevent
antenna signals from shorting to ground
❑ Removing and installing. Refer to
Removing and Installing”, page 32
.
4 - Right Antenna Module - R109-
❑ On the upper right of the rear lid
❑ Connected to Radio Antenna - R248-
❑ AM/FM impedance converter
❑ Removing and installing. Refer to
⇒ “3.4.2 Right Antenna Module R109 , Removing and Installing”, page 33
5 - Left Antenna Module - R108-
❑ On the upper left of rear lid
❑ Connected to Radio Antenna 2 - R93-
❑ Impedance converter FM2
❑ Removing and installing. Refer to
⇒ “3.4.1 Left Antenna Module R108 , Removing and Installing”, page 32
6 - Roof Antenna - RX5-
❑ Depending on the vehicle equipment level:
♦ GPS Antenna - R50-
♦ Satellite Antenna - R170-
♦ GSM Antenna - R205-
❑ Removing and installing. Refer to
3.1.2
Component Location Overview - Antenna Systems, Wagon
1 - FM Frequency Filter in Pos‐
itive Wire - R179-
❑ On the left window
frame of the rear lid
❑ FM plus trap circuit
❑ Its function is to prevent
antenna signals from
shorting to ground
❑ Removing and instal‐
ling. Refer to
2 - AM Frequency Filter -
R177-
❑ On the lower right of the
rear lid
❑ Its function is to prevent
antenna signals from
shorting to ground
❑ Removing and instal‐
ling. Refer to
3 - FM Frequency Filter in Neg‐
ative Wire - R178-
❑ On the right window
frame of the rear lid
❑ FM minus trap circuit
❑ Its function is to prevent
antenna signals from shorting to ground
❑ Removing and installing. Refer to
Removing and Installing”, page 32
4 - Right Antenna Module - R109-
❑ On the upper right of the rear lid
❑ Related to the Radio Antenna - R248-
❑ AM/FM impedance converter
❑ Removing and installing. Refer to
⇒ “3.4.2 Right Antenna Module R109 , Removing and Installing”, page 33
.
5 - Roof Antenna - RX5-
❑ Depending on the vehicle equipment level:
♦ GPS Antenna - R50-
♦ Satellite Antenna - R170-
♦ GSM Antenna - R205-
❑ Removing and installing. Refer to
⇒ “3.4.1 Left Antenna Module R108 , Removing and Installing”, page 32
.
6 - Left Antenna Module - R108-
❑ On the upper left of rear lid
❑ Related to the Radio Antenna 2 - R93-
❑ Impedance converter FM2
❑ Removing and installing. Refer to
⇒ “3.4.1 Left Antenna Module R108 , Removing and Installing”, page 32
3.2
AM Frequency Filter - R177- , Removing
and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
– Turn off the ignition and all electrical equipment.
– Then remove the ignition key, if equipped.
– Remove the lower rear lid trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Lower Rear
Lid Trim Panel, Removing and Installing .
– Release and disconnect the connectors -1 and 3- from the AM
Frequency Filter - R177- -2-.
– Remove the bolt -4-.
– Remove the AM Frequency Filter - R177- -1- from the rear lid
in direction of -arrow A-, while paying attention to the mounting
hooks.
Installing
Install in reverse order of removal. Note the following:
Tightening Specifications
Component
Tightening Specification
Bolt to AM Frequency Filter - R177-
6 Nm
3.3
FM Frequency Filter in the Negative
Wire - R178- / FM Frequency Filter in the
Positive Wire - R179- , Removing and
Installing
The removal and installation of the FM Frequency Filter in Neg‐
ative Wire - R178- on the right side is described. The removal and
installation of the FM Frequency Filter in Positive Wire - R179- on
the left side is identical.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the upper rear lid trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Upper Rear
Lid Trim Panel, Removing and Installing .
– Disconnect the connector -arrows- from the FM Frequency
Filter in Negative Wire - R178- .
– Carefully pry out the FM Frequency Filter in Negative Wire -
R178- near the -arrow- using a suitable tool.
Installing
Install in reverse order of removal. Note the following:
– Push the FM Frequency Filter in Negative Wire - R178- into
the installation opening until it engages.
3.4
Antenna Module, Removing and Instal‐
ling
⇒ “3.4.1 Left Antenna Module R108 , Removing and Installing”,
page 32
⇒ “3.4.2 Right Antenna Module R109 , Removing and Installing”,
3.4.1
Left Antenna Module - R108- , Remov‐
ing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
– Turn off the ignition and all electrical equipment.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст