Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 284
– Connect the connector -5- to the drive motor -1-.
– Check that the mount is seated correctly -4- in the slotted guide
rail guide -3-.
– Install the drive motor -1- and tighten the bolts -2-.
– After installing, the key can be reinserted into the lock cylinder
of the ignition/starter switch.
– Then perform a function test.
– Install the cover -1-.
– Tighten the bolts -3-.
– Install the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
Tightening Specifications
1.13.3
Power Sunroof Control Module - J245- ,
Removing and Installing, Wagon
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
WARNING
Only remove and install the Panorama sunroof glass panel
drive motor when the roof is closed (neutral position).
Requirements for removing and installing the drive motor: the
engine and the ignition must be off, remove the key and open
the door.
Removing
– Remove the front light and control unit. Refer to ⇒ Electrical
Equipment; Rep. Gr. 96 ; Lamps; Component Location Over‐
view - Roof Trim Panel Lamps .
– Remove the bolts -3-.
– Lower the sunroof motor -1- slightly and tilt it out toward the
back.
– Disconnect the connector -4-.
Installing
– Install the sunroof motor -1- and tighten the bolts -2-.
– Install the connector -4-.
– Remove the front light and control unit. Refer to ⇒ Electrical
Equipment; Rep. Gr. 96 ; Lamps; Component Location Over‐
view - Roof Trim Panel Lamps .
– After completing all work steps, perform an adaptation on the
sunroof motor. Refer to
⇒ “1.17 Power Sunroof Control Module J245 , Programming”,
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст