Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 230
– Remove the gas-filled struts -3-. Refer to
⇒ “2.12 Gas-Filled Strut, Removing and Installing”,
.
– Now remove the bolts -5- and the rear lid -1-.
Installing
– Install the rear lid -1- with a second technician.
– Install the gas-filled struts -3-. Refer to
⇒ “2.12 Gas-Filled Strut, Removing and Installing”,
.
– Guide the wires -2- into the rear lid and install the rubber
grommet.
– Connect the connectors of any electrical components.
Installation is performed in reverse order of the removal.
– Perform a function test on the unlocking components before
closing the rear lid.
– Adjust the rear lid. Refer to
⇒ “2.3 Rear Lid, Adjusting”, page 55
.
2.2.2
Rear Lid, Removing and Installing,
Wagon
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– Remove the rear lid upper trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Rear Lid
Upper Trim Panel, Removing and Installing .
– Remove the rear lid lower trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Rear Lid
Lower Trim Panel, Removing and Installing .
– Remove the high-mounted brake lamp. Refer to ⇒ Electrical
Equipment; Rep. Gr. 94 ; High-Mounted Brake Lamp; High-
Mounted Brake Lamp, Removing and Installing .
– Disconnect the connectors -2- from the equipped electrical
components.
– Guide the wires with the rubber grommet -5- out of the rear lid.
– Loosen the bolts -4- on the left and right hinges, but do not
remove them.
A second technician is required for the rest of the removal pro‐
cedure.
– Remove the gas-filled struts -3-. Refer to
⇒ “2.12 Gas-Filled Strut, Removing and Installing”,
.
– Now remove the bolts -4- and the rear lid -1-.
Installing
– Install the rear lid -1- with a second technician.
– Install the gas-filled struts -3-. Refer to
⇒ “2.12 Gas-Filled Strut, Removing and Installing”,
.
– Guide the wires -2- into the rear lid and install the rubber
grommet.
– Connect the connectors of any electrical components.
Installation is performed in reverse order of the removal.
– Perform a function test on the unlocking components before
closing the rear lid.
– Adjust the rear lid. Refer to
⇒ “2.3 Rear Lid, Adjusting”, page 55
2.3
Rear Lid, Adjusting
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Gauge - Gap Adjustment - 3371-
Note
♦
The vehicle must be on all four wheels when adjusting the rear lid.
♦
The latch -2- is bolted directly to the rear lid -1-. The latch cannot be adjusted.
♦
The left and right adjusting buffers -4- are not meant for adjusting. They stabilize and cushion the rear lid.
♦
The rear lid is properly adjusted when there is an overall even gap dimension when closed. It is not too far
inward or outward. And the contours align.
♦
The rear lid must engage in the striker without great force.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст