Volkswagen Passat / Passat Variant (2011 year). Manual — part 88
Before starting welding on right side panel, apply sealing cord -AKD 497 010 04 R10- in area of fuel filler neck.
Note
♦
In the area of the A, B and C-pillars, high tensile, highest tensile and hot formed steels are used. The weld
flanges in these areas are about 13mm wide.
♦
If spot welds are located at the edge of hot formed steel panels, the high temperature will cause the bond
between the panels to change, which will subsequently have an effect on crash safety.
Therefore, locate spot welds as close to the centre as possible.
• Dimension -a- of 8mm can be achieved using angled welding
tips.
– Adapt new part with vehicle standing on its wheels or align‐
ment bracket set and fix in position.
– Check fit with bolt-on parts.
Passat 2011 ➤ , Passat Variant 2011 ➤
12. Renewing side panel (Variant) - part section
349
seam.
– Weld in parting cuts, MIG solder seam or SG continuous weld
seam are permitted.
– Reform wheel housing flange.
– Wipe away excess adhesive and seal wheel arch.
Passat 2011 ➤ , Passat Variant 2011 ➤
350
and MIG staggered continuous seam or SG staggered con‐
tinuous weld seam.
– Weld in remaining joints to tail light mounting, SG plug weld
seam.
Passat 2011 ➤ , Passat Variant 2011 ➤
12. Renewing side panel (Variant) - part section
351
13
Renewing outer wheel housing liner
WARNING
Observe safety notes!
Welding, parting using spark generating machines/tools or tin‐
ning in foam treated areas creates gases which are hazardous
to health and environment. Therefore, refrain from using these
processes.
Safety notes ⇒ General Information; Body Repairs, General Body
Repairs ; Safety notes
• Side panel already removed
.
1 - Wheel housing liner
2 - Reinforcing plate
3 - Bonded areas
4 - Moulded foam element
5 - Lock reinforcement
Passat 2011 ➤ , Passat Variant 2011 ➤
352
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст