Volkswagen 01M Transmission. Manual — part 77
- Carefully press selector lever cable - 2 - onto selector
shaft lever. Do not bend lever/selector shaft when doing
this, otherwise shifting can no longer be adjusted
precisely.
- Replace lock washer - 1 - .
- Seat boot - arrow - so that it makes full contact against
shift unit.
- Install shift mechanism
37-2, Selector mechanism,
removing and installing
.
Cover, removing and installing
Removing
- Remove selector lever handle
37-2, Selector lever
handle, removing and installing
.
- The procedure for disconnecting the battery must
absolutely be obeyed.
- Disconnect battery Ground (GND) strap with ignition
switched off
Page 13 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
.
Repair Manual, Electrical Equipment, Repair Group 27,
- Remove cover from center console
.
Repair Manual, Body Interior, Repair Group 68,
- Disconnect connector - 1 - .
- Carefully pull off retaining clips - 2 - on left and right from
frame.
Installing
Installation is in reverse order of removal. Note the
following:
- Install cover to center console
.
Repair Manual, Body Interior, Repair Group 68,
- Connect battery
.
Repair Manual, Electrical Equipment, Repair Group 27,
- Install selector lever handle
37-2, Selector lever
handle, removing and installing
.
Page 14 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Frame, removing and installing
Removing
- Remove cover
37-2, Cover, removing and installing
.
- Pull retaining clips - arrows - outward on left and right
and remove frame upward.
Installing
Installation is in reverse order of removal.
- Install cover
37-2, Cover, removing and installing
.
Shifting selector lever out of "P" without electricity
(Manual release)
- Press solenoid core in direction of - arrow - from above
with a "long, thin" screwdriver.
The handle does not need to be removed for this.
Page 15 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Selector lever park position solenoid N380 , removing
and installing
Removing
- Remove shift mechanism
37-2, Selector mechanism,
removing and installing
.
- Release connector and pull off.
- Release solenoid from its mounting and pull it upward
and out from locking lever - 1 - and shift mechanism.
Installing
- Set solenoid lever - 2 - vertically.
- Set solenoid into mount of shift mechanism at a slight
angle.
- Attach lever - 2 - to locking lever - 1 - .
Page 16 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст