Volkswagen 01M Transmission. Manual — part 89
38 - 1
Oil pan, removing and installing
Special tools, testers and auxiliary items required
Drip tray V.A.G 1306
Torque wrench V.A.G 1331
Removing
- Remove noise insulation for transmission.
- Place drip tray V.A.G 1306 underneath.
Page 1 / 3
Oil pan, removing and installing
WWW.ALL-TRANS.BY
- Remove oil drain plug - 1 - .
- Drain ATF.
- Loosen oil pan bolts - 1 - in a diagonal pattern and
remove oil pan.
Installing
- Clean all magnets in depressions of the oil pan. Ensure
that the magnets are in full contact with the oil pan.
- Install oil pan with a new gasket - 1 - .
- Make sure that all spacer sleeves - 2 - are located
completely in the new gasket - 1 - .
- Tighten oil pan bolts in diagonal sequence and in stages
38-1, Torque specifications
.
Replace drain plug seal.
- Tighten oil drain plug
38-1, Torque specifications
.
- After installation, fill with ATF, check ATF level, and top
off
37-4, ATF level, checking
.
Torque specifications
Page 2 / 3
Oil pan, removing and installing
WWW.ALL-TRANS.BY
Drain plug
28 Nm
Oil pan bolts
8 Nm
Page 3 / 3
Oil pan, removing and installing
WWW.ALL-TRANS.BY
38 - 2
ATF strainer, removing and installing
Special tools, testers and auxiliary items required
Torque wrench V.A.G 1410
3 threaded studs M6 x 70 (self-fabrication)
Removing
- Remove oil pan
38-1, Oil pan, removing and
installing
.
- Remove bolts - arrows - .
- Pull off oil strainer.
Installing
Page 1 / 2
ATF strainer, removing and installing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст