Volkswagen 01M Transmission. Manual — part 88
37 - 7
Seals, replacing
Output shaft seal, replacing
Special tools, testers and auxiliary items
required
Puller T10055
Adapter T10055/2
Press Tool For Shaft Seal
T10180
Thrust piece T10186
Page 1 / 4
Seals, replacing
WWW.ALL-TRANS.BY
Removing
- Remove transfer case
37-3, Transmission, removing
and installing
.
- To pull out seal, install a sheet metal screw of approx. 4
mm diameter into seal - arrow - .
Install sheet metal screw in so that it jams between
seal and metal ring.
Do not screw in sheet metal screw too far to avoid
damaging bearing behind it.
- Pull out seal with puller T10055 .
Installing
- The new seal must be coated with ATF, especially at the
sealing lips.
Page 2 / 4
Seals, replacing
WWW.ALL-TRANS.BY
- First place Press Tool For Shaft Seal T10180 onto
output shaft, so that the seal cannot be damaged.
- Then, drive in the new seal up to the limit stop using
Press Tool For Shaft Seal T10180 . When doing this, do
not cant sealing ring.
- Then check ATF level and top off
37-4, ATF level,
checking and topping off
.
Selector shaft seals, replacing
Special tools, testers and auxiliary items required
Thrust piece T10174
Scriber
- Be careful when using scriber to removing seals.
Page 3 / 4
Seals, replacing
WWW.ALL-TRANS.BY
- Apply ATF to circumference and space between sealing
lips of the new seal.
Installation position:
The open side of the sealing ring faces transmission.
- Drive in new seals using thrust piece T10174 , thereby
not distorting the seal.
- Multi-function transmission range (TR) switch, installing
and adjusting
38-5, Multi-Function Transmission Range
(TR) Switch F125 , removing, installing and adjusting
.
Page 4 / 4
Seals, replacing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст