Volkswagen 01M Transmission. Manual — part 90
- Push new gasket - 1 - onto intake flange of oil strainer -
2 - and wet with ATF.
The threaded studs M6 x 70 - arrows - are needed to
guide oil strainer.
- Install 3 threaded studs M6 x 70 into valve body by
hand.
- Place oil strainer onto threaded studs .
- Carefully press suction collar into opening at valve body
up to stop.
- Fasten bolts - arrows - for oil strainer
38-2, Torque
specifications
.
- Install oil pan
38-1, Oil pan, removing and installing
.
- After installation, fill with ATF, check ATF level, and top
off
37-4, ATF level, checking
.
Torque specifications
Oil strainer bolts
10 Nm
Page 2 / 2
ATF strainer, removing and installing
WWW.ALL-TRANS.BY
Automatic Transmission Hydraulic Pressure Sensor
1 G193 and Automatic Transmission Hydraulic
Pressure Sensor 2 G194 , removing and installing
Senders must always be replaced together.
Special tools, testers and auxiliary items required
Torque wrench V.A.G 1410
Removing
- If still installed, remove oil pan
38-1, Oil pan, removing
and installing
and oil strainer
38-2, ATF strainer,
removing and installing
.
- Carefully pull off connectors for Automatic Transmission
Hydraulic Pressure Sensor 1 G193 - 1 - and Automatic
Transmission Hydraulic Pressure Sensor 2 G194 - 2 - .
- Remove both sensors.
Installing
Sensors must always be replaced together.
Page 1 / 2
Automatic Transmission Hydraulic Pressure Sensor 1 G193 and Automatic Transmissi...
Volkswagen Technical Site: http://volkswagen.msk.ru http://vwts.info http://vwts.ru
огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi
WWW.ALL-TRANS.BY
- Install 2 new sensors and fasten to 5 Nm.
- Push connectors onto sensors - 1 - and - 2 - up to
stop.
The connectors must engage.
- Install oil strainer
38-2, ATF strainer, removing and
installing
and oil pan
38-1, Oil pan, removing and
installing
.
- After installation, fill with ATF, check ATF level, and top
off
37-4, ATF level, checking
.
Page 2 / 2
Automatic Transmission Hydraulic Pressure Sensor 1 G193 and Automatic Transmissi...
WWW.ALL-TRANS.BY
38 - 4
Valve body, overview
The valve body and/or the lines can be removed and
installed with transmission either removed or
installed.
Solenoid Valve 2 N89
Connector for Transmission
Output Speed (RPM) Sensor
G195
The sensor is located behind
valve body
Automatic Transmission
Hydraulic Pressure Sensor 2
G194
Page 1 / 4
Valve body, overview
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст