Volkswagen Jetta / Jetta Hybrid. Manual — part 71
5.4.1
Removing
Note
The trim cannot be removed without being damaged.
Carry out following work:
– Press spreader pins -5- slightly into clips -3- -arrow a-.
Note
Spreader pins -5- remain in grommets -4-.
– Pull out clips -3-.
– Pull trim cover -1- with securing pins -2- out of grommets.
– Take spreader pins -5- out of grommets -4-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
5. Mouldings and trims
281
Carry out following work:
Note
Check grommets -4- for damage and renew if necessary.
– Place trim -1- against B-pillar.
– Press trim securing pins -2- into grommets -4-.
– Insert clips -3- and press spreader pins -5- into clips
-arrow a-.
5.5
Side member extension “GLI”
Note
The removal and installation sequence is for the left side member
(sill) extension. The removal and installation of the right side
member (sill) extension is similar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
282
Carry out following work:
– Release locking tabs of clips -3- and remove clips from side
member extension -1- as far as stop -arrow a-.
– Heat up adhesive tape -4- on top of side member extension
-1- using hot air blower -V.A.G 1416- .
– Carefully remove adhesive tape -4- between side member and
side member extension -1- (e.g. with a plastic wedge).
– Push side member extension -1- forwards -arrows b- until it
can be removed from securing screws -2- (qty. 5) -arrows c-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
5. Mouldings and trims
283
Note
♦
Screws for side member extension are corrosion-resistant. No secondary treatment is required.
♦
If the screw is overtightened it is essential to replace it with a “black” oversize screw.
Carry out following work:
• No holes present for securing screws.
– Measure out required holes for securing screws using table
below (
⇒ page 285
).
– Use punch to centre measured points for holes and pilot-drill
holes with 1.5 mm drill bit.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
284
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст