Volkswagen Jetta / Jetta Hybrid. Manual — part 30
Assembly overview - battery for folding key with remote control
1 - Key with variable code
transponder
2 - Transmitter unit - upper part
3 - LED
❑ When remote control is
operated, this LED must
flash briefly.
❑ If LED does not flash
during remote control
operation, the battery is
dead and must be re‐
newed.
4 - Battery
❑ Removing and installing
⇒ page 118
5 - Transmitter unit - lower part
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Central locking
117
ing key with remote control
3.4.1
Removing
Carry out following work:
– Insert screwdriver in slot between transmitter unit -1- and key
-2-.
– Turn screwdriver in direction of -arrow- to separate transmitter
unit from key.
– Press transmitter unit -1- apart using profile section of key
-2-.
– Unclip battery -1- from the retainers -2- with a screwdriver in
direction of -arrow-.
3.4.2
Installing
Note
♦
Before installing battery, always press one of the buttons once.
♦
Thus transmitter unit is reset and can recognize a new battery
only now.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
118
-2- (positive terminal is marked on housing).
– Press battery into -arrow- radio container until it latches into
place, applying only slight pressure while doing so.
– Attach lid and sender unit to each other (do not damage seal).
– Then clip transmitter unit to the key.
3.5
Assembly overview - battery for folding key with cover cap
1 - Key with radio capsule
❑ Adapting keys with re‐
mote control
⇒ page 116
❑ Radio capsule can not
be renewed individually.
2 - LED
❑ When remote control is
operated, this LED must
flash briefly.
❑ If LED does not flash
during remote control
operation, the battery is
dead and must be re‐
newed.
3 - Battery
❑ Removing and installing
⇒ page 120
4 - Cover
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Central locking
119
ing key with cover cap
3.6.1
Removing
Carry out following work:
– Fold out profile section of key.
– Using a screwdriver, unclip cover cap -1- on back of key -2- in
-direction of arrow-.
– Using a suitable screwdriver, unclip battery -1- from battery
compartment of key -2- in -direction of arrow-.
3.6.2
Installing
Note
♦
Before installing battery, always press one of the buttons once.
♦
Thus transmitter unit is reset and can recognize a new battery
only now.
Carry out following work:
Ensure correct polarity and mounting position when installing bat‐
tery.
– Insert battery -1- -arrow- into battery compartment of key -2-
with positive terminal pointing upwards.
– Press battery into battery compartment until it latches into
place, applying only slight pressure while doing so.
– Clip cover cap onto back of key.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
120
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст