Volkswagen Jetta / Jetta Hybrid. Manual — part 58
Carry out following work:
– Insert window regulator -1- together with cable drum through
opening in door and move to mounting position -arrows a- and
-b-.
– Insert threaded bolts of window regulator through the door
skin.
– Screw on nuts -2- and tighten.
Specified torque for nuts -2-: 8 Nm
– Insert guides of cable drum through door skin until locking
hooks engage -arrows c-.
– Install window regulator motor
⇒ page 225
– Install door window
⇒ page 221
– Fit cover
⇒ page 130
.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Rear door window
229
nel
Note
Removal and installation is described only for the right window
channel. The removal and installation of the left window channel
is similar.
3.6.1
Removing
Carry out following work:
– Remove door window
⇒ page 221
.
– Pull out retaining clip -3- -arrow c-.
– Peel sealing lip of window channel -1- off the door flange from
the inside.
– Pull window channel -1- -arrows a- off flange -2- uniformly all
around it.
– Pull window channel -1- out of mountings -arrows b-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
230
Carry out following work:
– Openings -4- beneath window channel are masked off with
textile adhesive tape.
Adhesive tape dimensions: height = approx. 10 mm, width = ap‐
prox. 40 mm.
– Spray window channel with soapy water to facilitate installa‐
tion.
– Push window channel -1- into mountings on fixed door window
-arrow a-.
– Push window channel -1- of fixed door window evenly all
around onto the door flange -2- as far as B-pillar.
– Fold sealing lip of window channel onto door flange from the
inside as far as B-pillar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Rear door window
231
To prevent wind noise, ensure window channel -1- seats evenly when installing.
♦
The window channel is installed at the B-pillar after installation of the door window.
– Push in retaining clip -3- -arrow c-.
Note
♦
Retaining clip inclination must point to inner side of vehicle (vehicle interior).
♦
If retaining clip inclination points to outer side of vehicle -scored through in red-, retaining clip must be turned
around.
Further installation is performed in the reverse order of removal.
3.7
Removing and installing fixed door win‐
dow
Note
Removal and installation are described only for the right fixed
door window. Removal and installation of the left fixed door win‐
dow is analogous.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
232
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст