Volkswagen Jetta / Jetta Hybrid. Manual — part 57
tor motor
Note
The removal and installation sequence is only for the right window
regulator motor. The removal and installation of the left window
regulator motor is similar.
3.4.1
Removing
gr. 70 ; Door trim .
– Secure door window against sliding down with adhesive tape.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Rear door window
225
– Disconnect connector -3-.
– Remove the three screws -2-.
– Remove window regulator motor together with control unit
-1- from mounting brackets.
3.4.2
Installing
WARNING
If a new window regulator motor is installed (door control unit),
the additional functions and the excess force limitation feature
have to be coded!
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
226
the splines between window regulator motor and cable drum
engage more easily.
– Screw in the three screws -2-.
Specified torque for bolts -2-: 4 Nm.
– Connect connector -3-.
– A new window regulator motor must be coded using the vehi‐
cle diagnosis, testing and information system -VAS 5051B- .
– The work procedure and notes on the automatic window rais‐
ing and lowering system as well as on the excess-force limi‐
tation feature can be found in ⇒ Maintenance ; Booklet .
Further installation is performed in the reverse order of removal.
3.5
Removing and installing window regula‐
tor
Note
Removal and installation are described only for the right window
regulator. The removal and installation of the left window regulator
is similar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Rear door window
227
Carry out following work:
– Remove cover
⇒ page 130
.
– Remove door window
⇒ page 221
.
– Removing window regulator motor
⇒ page 225
– Release locking hook of cable drum -arrows d- and push cable
drum -3- into door.
– Undo nuts -2- and push threaded bolts of window regulator
into door.
– Lever out window regulator -1- together with cable drum
through opening in door -arrows b- and -c-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
228
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст