Nissan Rogue. Instruction — part 269
DAS
C1BC0-00 FRONT RIGHT WHEEL SENSOR
DAS-247
< DTC/CIRCUIT DIAGNOSIS >
[CHASSIS CONTROL]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
4. Perform “All DTC Reading”.
Is DTC “C1BC0-00”, “U1000-00” or other DTC detected?
YES (“C1BC0-00”)>>Replace the chassis control module. Refer to
DAS-286, "Removal and Installation"
.
YES (“U1000-00”)>>Refer to
DAS-260, "Diagnosis Procedure"
YES (other DTC)>>Check the DTC.
NO
>> Inspection End.
DAS-248
< DTC/CIRCUIT DIAGNOSIS >
[CHASSIS CONTROL]
C1BC1-00 FRONT LEFT WHEEL SENSOR
C1BC1-00 FRONT LEFT WHEEL SENSOR
DTC Description
INFOID:0000000011277418
DTC DETECTION LOGIC
POSSIBLE CAUSE
• Front left wheel sensor
• Front left sensor rotor
• ABS actuator and electric unit (control unit)
• Chassis control module
FAIL-SAFE
The following functions are suspended:
• Active Trace Control function
• Active Ride Control function
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF
and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute.
3. Stop the vehicle.
4. Turn the ignition switch OFF to ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
5. Perform “Self Diagnostic Result” of “CHASSIS CONTROL”.
Is DTC “C1BC1-00” detected?
YES
>> Proceed to
DAS-248, "Diagnosis Procedure"
NO-1 >> To check malfunction symptom before repair: Refer to
GI-44, "Intermittent Incident"
.
NO-2 >> Confirmation after repair: Inspection End.
Diagnosis Procedure
INFOID:0000000011277419
1.
CHECK FRONT LH WHEEL SENSOR SYSTEM
With CONSULT
Perform “Self Diagnostic Result” of “ABS”.
Is DTC detected?
YES
>> Check the DTC. Refer to
.
NO
>> GO TO 2.
2.
PERFORM SELF-DIAGNOSIS
With CONSULT
1. Erase “Self Diagnostic Result” of “CHASSIS CONTROL”.
2. Turn the ignition switch OFF and wait for 10 seconds or more.
3. Turn the ignition switch ON.
DTC
Display Item
(Trouble diagnosis content)
Malfunction detected condition
C1BC1-00
FL WHEEL SENSOR
(Front left wheel sensor)
When a malfunction is detected in front left wheel sensor system.
DAS
C1BC1-00 FRONT LEFT WHEEL SENSOR
DAS-249
< DTC/CIRCUIT DIAGNOSIS >
[CHASSIS CONTROL]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
4. Perform “All DTC Reading”.
Is DTC “C1BC1-00”, “U1000-00” or other DTC detected?
YES (“C1BC1-00”)>>Replace the chassis control module. Refer to
DAS-286, "Removal and Installation"
.
YES (“U1000-00”)>>Refer to
DAS-260, "Diagnosis Procedure"
YES (other DTC)>>Check the DTC.
NO
>> Inspection End.
DAS-250
< DTC/CIRCUIT DIAGNOSIS >
[CHASSIS CONTROL]
C1BC2-00 REAR RIGHT WHEEL SENSOR
C1BC2-00 REAR RIGHT WHEEL SENSOR
DTC Description
INFOID:0000000011277420
DTC DETECTION LOGIC
POSSIBLE CAUSE
• Rear right wheel sensor
• Rear right sensor rotor
• ABS actuator and electric unit (control unit)
• Chassis control module
FAIL-SAFE
The following functions are suspended:
• Active Trace Control function
• Active Ride Control function
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF
and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute.
3. Stop the vehicle.
4. Turn the ignition switch OFF to ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
5. Perform “Self Diagnostic Result” of “CHASSIS CONTROL”.
Is DTC “C1BC2-00” detected?
YES
>> Proceed to
DAS-250, "Diagnosis Procedure"
NO-1 >> To check malfunction symptom before repair: Refer to
GI-44, "Intermittent Incident"
.
NO-2 >> Confirmation after repair: Inspection End.
Diagnosis Procedure
INFOID:0000000011277421
1.
CHECK REAR RH WHEEL SENSOR SYSTEM
With CONSULT
Perform “Self Diagnostic Result” of “ABS”.
Is DTC detected?
YES
>> Check the DTC. Refer to
.
NO
>> GO TO 2.
2.
PERFORM SELF-DIAGNOSIS
With CONSULT
1. Erase “Self Diagnostic Result” of “CHASSIS CONTROL”.
2. Turn the ignition switch OFF and wait for 10 seconds or more.
3. Turn the ignition switch ON.
DTC
Display Item
(Trouble diagnosis content)
Malfunction detected condition
C1BC2-00
RR WHEEL SENSOR
(Rear right wheel sensor)
When a malfunction is detected in rear right wheel sensor system.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст