Hyundai Getz: Body Repair Manual — part 24
101
BODY PANEL REPAIR PROCEDURE - Side sill (Assembly)
3.
Cut the side sill outer panel along cutlines. Be careful not to cut
mating flanges.
4.
Drill out all spotwelds, attaching the side sill outer panel to side
outer reinforcement.
5.
Remove the side sill outer panel.
6.
Determine if the side outer reinforcement is damaged and needs
to be replaced, measure cutline on reinforcement as shown in the
illustration.
7.
Cut side sill outer reinforcement along the cutline.
8.
Drill out spotwelds attaching the side outer reinforcement to the
body and remove side outer reinforcement.
9.
Prepare all surfaces to be welded.
INSTALLATION
1.
Transcribe cutline dimension to side sill outer panel, adding
30mm overlap to rear end and cut to length.
2.
Drill 8mm holes in overlap area on rear end and along front flange.
3.
Fit and clamp the side sill outer reinforcement in place.
4.
MIG plug weld all holes and MIG butt weld seams.
5.
Before welding the side sill outer panel, apply the two-part epoxy
primer and anti-corrosion agent to the welded parts.
NOTE
The reinforcement will be stronger if the weld traces are not
ground.
PRO-1020
PRO-1020
PRO-1030
PRO-1040
102
BODY PANEL REPAIR PROCEDURE - Side sill (Assembly)
7.
Crimp flanges on the remaining portion of the side sill outer panel
at all joint for overlap.
8.
Fit and clamp the side sill outer panel in place.
9.
MIG plug weld all holes and MIG butt weld seams.
10. Clean and prepare all welds and remove all residue.
11. Apply body filler to the side sill outer seams.
12. Apply the two-part epoxy primer to the interior of the side sill.
13. Apply an anti-corrosion agent to welded parts and interior of the
side sill (Refer to the CORROSION PROTECTION).
14. Prepare the exterior surfaces for priming, using wax and grease
remover.
15. Apply metal conditioner and water rinse.
16. Apply conversion coating and water rinse.
17. Apply the two-part epoxy primer.
6.
Using service panel for replacement of side sill outer panel, drill
8mm holes in overlap areas and along upper and lower flanges.
18. Apply the correct seam sealer to all joints (Refer to the BODY
SEALING LOCATIONS).
19. Reprime over the seam sealer.
PRO-1050
PRO-1060
PRO-1180
PRO-1080
103
BODY PANEL REPAIR PROCEDURE - Side sill (Assembly)
20. Apply the anti-corrosion primer to the side sill outer panel to
complete the repair (Refer to the CORROSION PROTECTION).
PRO-1090
104
SIDE SILL (PARTIAL)
REMOVAL
1.
Depending on the extent of damage, mark out the damaged
portion of the side sill.
2.
Drill out the spotwelds in upper and lower flanges of side sill
between cutlines to remove side sill outer panel and cut the
damaged portion of the side sill at the cutlines.
BODY PANEL REPAIR PROCEDURE - Side sill (partial)
z
z
z
z
z MIG plug welding
MIG butt welding
WELDLING POINTS
PRO-1100
PRO-0500
PRO-1120
30mm
30mm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст