Hyundai Santa Fe (2006 year). Manual — part 788
REAR SUSPENSION SYSTEM
SS -59
REMOVAL
E46DA66A
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely sup-
ported.
2.
Remove the rear wheel and tire (A) from the rear hub
(B).
A
B
C
SCMSS6512D
CAUTION
Be careful not to damage to the hub bolts (C) when
removing the rear wheel and tire (A).
3.
Remove the assist arm (A) from the rear carrier.
A
C
B
SCMSS6031D
NOTE
Remove the rear assist arm ball joint (A) by using the
special tool(09568-4A000).
09568-4A000
SCMSS6523D
CAUTION
If the bush is excessive worn and damaged, re-
place the assist arm assembly.
SS -60
SUSPENSION SYSTEM
INSPECTION
EDACAA4A
1.
Check the bushing for wear and deterioration.
2.
Check the rear assist arm for bending or breakage.
3.
Check the ball joint dust cover for cracks.
4.
Check all bolts.
INSTALLATION
EC8E3BD8
1.
Install the rear assist arm (A) to the rear carrier.
Tightening torque Nm (kgf-m, lb-ft) :
Bolt(B) : 137.3~156.9 (14~16, 101.3~115.7)
Nut(C) : 98.1~117.7 (10.0~12.0, 72.3~86.8)
A
C
B
SCMSS6031D
NOTE
After checking the distance(453±10mm(17.83
±0.39in)) between the wheel housing garnish (A) and
the hub assembly (B) as shown in the illustration,
tighten the mounting bolts and nuts of rear chassis
part with specified torque.
A
B
453 10 mm
SCMSS6528D
2.
Install the wheel and tire (A) to the rear hub (B).
Tightening torque Nm (kgf-m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
A
B
C
SCMSS6512D
CAUTION
Be careful not to damage the hub bolts (C) when
installing the rear wheel and tire (A).
REAR SUSPENSION SYSTEM
SS -61
TRAILING ARM
COMPONENT
E39A3EAF
1. Rear trailing arm
137.3~156.9
(14~16, 101.3~115.7)
137.3~156.9
(14~16, 101.3~115.7)
1
TORQUE : Nm (kgf.m, lb-ft)
SCMSS6509L
SS -62
SUSPENSION SYSTEM
REMOVAL
EBA34130
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely sup-
ported.
2.
Remove the rear wheel and tire (A) from the rear hub
(B).
A
B
C
SCMSS6512D
CAUTION
Be careful not to damage to the hub bolts (C) when
removing the rear wheel and tire (A).
3.
Remove the trailing arm (A) from the rear carrier.
A
C
B
SCMSS6039D
CAUTION
If the bush is excessive worn and damaged, re-
place the assist arm assembly.
INSPECTION
EDFCCDEE
1.
Check the bushing for wear and deterioration.
2.
Check the rear trailing arm for bending or breakage.
3.
Check all bolts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст