Hyundai Santa Fe (2006 year). Manual — part 789
REAR SUSPENSION SYSTEM
SS -63
INSTALLATION
EC498CBE
1.
Install the rear trailing arm (A) to the rear carrier.
Tightening torque Nm (kgf-m, lb-ft) :
Bolt(B) : 137.3~156.9 (14~16, 101.3~115.7)
Nut(C) : 137.3~156.9 (14~16, 101.3~115.7)
A
C
B
SCMSS6039D
NOTE
After checking the distance(453±10mm(17.83
±0.39in)) between the wheel housing garnish (A) and
the hub assembly (B) as shown in the illustration,
tighten the mounting bolts and nuts of rear chassis
part with specified torque.
A
B
453 10 mm
SCMSS6528D
2.
Install the wheel and tire (A) to the rear hub (B).
Tightening torque Nm (kgf-m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
A
B
C
SCMSS6512D
CAUTION
Be careful not to damage the hub bolts (C) when
installing the rear wheel and tire (A).
SS -64
SUSPENSION SYSTEM
REAR STABILIZER BAR
COMPONENT
E4306EFA
1. Rear stabilizer bar
2. Rear stabilizer link
3. Rear stabilizer bar bushing
4. Rear stabilizer bar bracket
TORQUE : Nm (kgf.m, lb-ft)
58.8~78.5
(6.0~8.0, 43.4~57.9)
58.8~78.5
(6.0~8.0, 43.4~57.9)
44.1~53.9
(4.5~5.5, 32.5~39.8)
1
3
4
2
SCMSS6510L
REAR SUSPENSION SYSTEM
SS -65
REMOVAL
EE1591DC
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely sup-
ported.
2.
Remove the rear wheel and tire (A) from the rear hub
(B).
A
B
C
SCMSS6512D
CAUTION
Be careful not to damage to the hub bolts (C) when
removing the rear wheel and tire (A).
3.
Support the rear lower arm with a jack as shown in
the illustration.
SCMSS6526D
4.
Remove the rear shock absorber (A).
A
SCMSS6514D
5.
Remove the brake caliper mounting bolts (A), and
then place the brake caliper assembly (B) with wire
as shown in the illustration.
A
B
SCMSS6515D
B
SCMSS6516D
SS -66
SUSPENSION SYSTEM
6.
Remove the wheel speed sensor (A) and the parking
brake cable (B) from the rear axle carrier.
A
B
SCMSS6517D
7.
After making a match mark (C) on the rubber coupling
(A) and rear differential companion (B), remove the
propeller shaft mounting bolts (D).
A
D
C
B
SCMSS6518D
8.
Support the rear cross member assembly (A) with the
jack.
A
SCMSS6010D
9.
Remove the rear cross member stay (A) and mounting
bolt (B) and nut (C).
B
A
C
SCMSS6011D
10. Remove the rear cross member mounting bolts (A),
nuts (B) and plate (C).
A
C
SCMSS6012D
B
C
SCMSS6013D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст