Chrysler Crossfire. Manual — part 971
Note: All
old
cover
retaining
clips
must
be
removed from the rear bow before the new cover
is to be installed.
Note: The new cover will have a center mark that
needs to be aligned with the rear bow latch.
3. Install the cover (1) onto the rear bow (2). Push the
cover into the rear bow firmly until the cover retain-
ing clips are engaged into the rear bow.
4. Install the rear bow weather strip (2) onto the rear
bow (1).
ZH
CONVERTIBLE TOP
23 - 555
5. Lift up the rear bow and connect the rear defogger
harness connectors (1).
6. Install the right and left cover (1) rear retaining
straps (3) with new rivets (2) (left side shown, right
side similar).
23 - 556
CONVERTIBLE TOP
ZH
7. Install the cover side retainers to the top frame by
sliding the retainer into the frame and pushing up
to lock into place.
8. Install the right and left new retaining rivets (1) (left
side shown, right side similar).
9. Install both rear side weather strips (1).
10. Connect both of the front cover support cables
(left side shown, right side similar).
ZH
CONVERTIBLE TOP
23 - 557
11. Install the cover support cables (1) into the cover
(2) (left side shown, right side similar).
12. Manually place the top in the upright position.
13. Attached the front cover retaining straps with new
rivets (1) (one each side) (left side shown, right
side similar).
23 - 558
CONVERTIBLE TOP
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст