SsangYong Korando II (1996-2006 year). Manual — part 178
OM600 ENGINE MECHANICAL 1B3 -- 161
DAEWOO MY_2000
Installation Procedure
1. Put the same alignment mark on the new crankshaft
sprocket as in the old sprocket.
Notice
Check the timing chain, camshaft sprocket, injection
pump timing sprocket, oil pump chain and oil pump
sprocket for wear and replace if necessary.
2. Install the new crankshaft sprocket (12) by using a
drift (21).
Notice
Align the groove of sprocket and woodruff key (ar-
row) exactly.
Drift 116 589 07 15 00
3. Fit the timing chain (4) on the crankshaft sprocket
(12).
Notice
Align the alignment marks (arrow) on the chain and
sprocket.
4. Install the camshaft sprocket (3).
Tightening Torque
25 N∙m (18 lb-ft) + 90_
Notice
Pay attention on the alignment marks and dowel pin
(arrow).
1B3 -- 162 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
Notice
If the max. length ’L’ of the stretch bolt exceeds
53.6mm, replace it.
5. Fit the oil pump chain (9) on the crankshaft sprocket
(12) and insert the oil pump sprocket (8) into the oil
pump chain and then install it on the oil pump.
Notice
The curved side of the oil pump sprocket should
face the oil pump.
6. Insert the woodruff key (15).
7. Install the guide rail (16). Attach the spring (17) to
guide rail and to tensioning lever together onto the
bearing pins (5,6).
Notice
Ensure that the spring is correctly located in the
guide rail (arrow).
OM600 ENGINE MECHANICAL 1B3 -- 163
DAEWOO MY_2000
PISTON
Preceding Work : Removal of cylinder head
Removal of the oil pump
1 Oil Ring
2 2nd Ring
3 Top Ring
4 Snap Ring
Replace
. . . . . . . . . . . . . . . . . . . . . . . .
5 Piston Pin
6 Piston
7 Connecting Rod Bushing
Check
. . . . . . . . . . . .
8 Connecting Rod
9 Connecting Rod Upper Bearing Shell
10 Connecting Rod Lower Bearing Shell
11 Connecting Rod Bearing Cap
12 Connecting Rod Bolt
35N∙m (26 lb-ft)+90_
. . .
13 Crankcase
14 Cylinder Bore
Notice
There are two kinds of connecting rods (for machining) and they are different in weight approx. 15g. When replac-
ing the connecting rod, measure its weight and ensure that a engine has the same weight of connecting rods. If
not, there would be a unbalancing of engine.
1B3 -- 164 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
Service Data
Piston clearance
Max. 0.12 mm
Piston crown protrusion in TDC position
0.735 -- 0.965 mm
Connecting rod bushing diameter
26.012 -- 26.018 mm
Connecting Rod Bolt Dimensions
Thread
M9 x 1
Stretch shaft(C) diameter (new)
7.4
-0.1
mm
Minimum stretch shaft diameter (C)
7.1 mm
Length(L)(new)
52
-0.3
mm
Tools Required
000 589 04 14 00 Tensioning Strap
001 589 53 21 00 Dial Gauge
363 589 02 21 00 Dial Gauge Holder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст