SsangYong Korando II (1996-2006 year). Manual — part 375
SSANGYONG MY2002
6E-12 POWER STEERING AND COLUMN
KAA6E040
KAA6E120
STEERING COLUMN
Important: Remove the steering column only if the
following conditions exist:
•
The steering column requires replacement.
•
The steering and the ignition lock housing require
replacement.
•
Another operation requires the removal of the
steering column
Notice: The steering column is extremely
susceptible to damage after it has been removed
from the vehicle. Dropping the column assembly
on its end or hammering the end of the steering
shaft can collapse the steering shaft or loosen the
plastic injections which maintain column rigidity.
Leaning on the column can cause it to bend or
deform. Any of the above damage can impair the
column’s collapsible design. If it is necessary to
remove the steering wheel, use only the specified
steering wheel puller.
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the upper and the lower steering column
cover screws.
3. Remove the upper and the lower steering column
cover.
KAA6E060
4. Remove the lower instrument trim panel. Refer to
Section 9E, Instrumentation/Driver Information.
5. Remove the immoblilzer module. Refer to Section
9T, Immobilizer Anti-Theft system.
6. Disconnect the airbag electrical connections.
7. Disconnect electrical switch connections.
8. Adjust the steering to the straight-ahead position.
9. Make a mark on the steering column shaft that
lines up with a mark on the intermediate shaft
upper universal joint.
10. Remove the intermediate shaft upper pinch bolt.
Installation Notice
Tightening Torque
27 N•m (20 lb-ft)
POWER STEERING AND COLUMN 6E-13
SSANGYONG MY2002
KAA6E130
11. Remove the steering column lower mounting nuts.
Installation Notice
KAA6E140
12. Remove the steering column upper mounting bolts
that hold the rear bracket of the steering column
jacket assembly.
13. Guide the steering column assembly out of the
steering shaft flange and carefully lay down the
assembly.
Installation Notice
•
Provide support for the steering column assem-
bly until the mounting bolts are fastened. Do
not let the steering column assembly hang
unsupported.
Tightening Torque
22 N•m (16 lb-ft)
Tightening Torque
22 N•m (16 lb-ft)
SSANGYONG MY2002
6E-14 POWER STEERING AND COLUMN
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
N • m
27
65
22
22
Lb-Ft
20
48
16
16
Intermediate Shaft Upper Pinch Bolt
Steering Wheel Nut
Steering Column Lower Mounting Nuts
Steering Column Lower Mounting Bolts
Lb-In
-
-
-
-
Application
POWER STEERING AND COLUMN 6E-15
SSANGYONG MY2002
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
661 589 00 33 00
Steering Wheel Puller
KAA6E150
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст