SsangYong Korando II (1996-2006 year). Manual — part 18
1B1 -- 38 M162 ENGINE MECHANICAL
DAEWOO MY_2000
CRANKSHAFT FRONT RADIAL SEAL
Preceding Work: Removal of belt pulley and vibration damper
1 Center Bolt (M18 x 50)
1st step 200+20 NSm (148+15 lb-ft)
. . . . . . . . . .
2nd step 90°+10°
2 Center Bolt Washer
3 Crankshaft Front Seal Installer
4 Crankshaft Front Seal
5 Key
M162 ENGINE MECHANICAL 1B1 -- 39
DAEWOO MY_2000
Tools Required
601 589 03 14 00 Crankshaft Front Seal Installer
Replacement Procedure
1. Remove the radial seal with a screw driver.
Notice: Use a clean cloth not to damage the radial seal
mounting hole and the crankshaft.
2. Coat the radial sealing lip with engine oil.
3. Using the crankshaft front seal installer 601 589 03 14
00, assemble the radial seal .
4. Align the sleeve groove and the woodruff key and
tighten the center bolt until the center bolt and the
damper disk stop in the movement.
Installation Notice
Tightening Torque
1st step: 200 + 20 NSm
(148 + 15 lb-ft)
Tightening Torque
2nd step: 90° + 10°
5. Remove the crankshaft front seal installer 601 589 03
14 00, and install the belt pulley and the vibration
damper.
6. Check for leaks while operating the engine.
1B1 -- 40 M162 ENGINE MECHANICAL
DAEWOO MY_2000
CRANKSHAFT REAR RADIAL SEAL
Preceding Work: Removal of flywheel or drive plate
1 Special Tool
2 Special Tool
3 Crankshaft Rear Seal
Tools Required
601 589 03 43 00 Crankshaft Rear Seal Installer
Replacement Procedure
1. Remove the radial seal with a screw driver.
Notice: Use a clean cloth not to damage the radial seal
mounting hole and the crankshaft.
2. Install the special tool (2) to the crankshaft.
3. Apply the engine oil on the special tool (2).
Notice: Do not use the grease.
4. Install the radial seal on the inner parts assembler.
5. Press in the special tool (1) until the radial seal is
stopped.
6. Check for leaks while operating the engine.
M162 ENGINE MECHANICAL 1B1 -- 41
DAEWOO MY_2000
CRANKSHAFT
Preceding Work: Removal of engine assembly
Removal of timing gear case cover
Removal of cylinder head
Removal of oil pump
Removal of oil shield
1 12--sided Stretch Bolt
55 NSm (41 lb-ft) + 90°, Iubricate
. . . . . . . . . . . .
2 Crank Shaft Bearing Cap
3 Crank Shaft Low Main Bearing
4 Lower Thrust Bearing
5 Crankshaft
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст