SsangYong Rexton. Manual — part 489
REAR AXLE 3D-9
SSANGYONG Y200
8. Remove the four fixing bolt of dust shield cover
and then pull out the dust shield cover.
YAD3D090
YAD3D100
YAD3D080
9. Remove the two plastic plug in the axle shaft
flange.
10. Remove the four fixing bolts & washers of axle
housing flange from the retainer plate.
11. Remove the rear axle drive shaft.
YAD3D070
7. Remove the brake disc.
SSANGYONG Y200
3D-10 REAR AXLE
YAD3D130
YAD3D140
YAD3D120
2. Tighten the flange fixing bolts and washers with
the retainer plate.
Installation Notice
3. Assemble the plastic plug n the rear axle flange
and install the dust shield.
Installation Notice
4. Install the brake disc and caliper assembly.
Installation Notice
5. Install the parking brake cable and tire.
50 - 65 N•m
(37 - 48 lb-ft)
Tightening torque
4 - 8 N•m
(35 - 71 lb-in)
Tightening torque
Tightening torque
85 - 105 N•m
YAD3D110
Installation
Clean the detached axle shaft, check the damage or
wear.
1. After checking the spline & shaft of rear axle shaft,
assemble the shaft into the rear axle housing.
REAR AXLE 3D-11
SSANGYONG Y200
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
AXLE SHAFT ASSEMBLY
(WITH DRUM BRAKE)
Removal
1. Release the parking brake.
2. Remove the tire.
YAD3D160
YAD3D170
YAD3D180
YAD3D190
3. Remove the brake drum.
Notice: Insert the bolt into the ser vice hole, while
tightening the both side bolts uniformly, remove
the brake drum.
4. Remove the fixing pin of parking brake.
5. After detaching the cover of parking brake,
disconnect the cable.
6. After pulling out the two plastic plug of axle shaft
flange, remove the fixing nuts of inner bracket.
SSANGYONG Y200
3D-12 REAR AXLE
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
7. Remove the axle shaft.
YAD3D200
YAD3D210
YAD3D230
YAD3D220
Tightening Torque
50 - 65 N•m
(37 - 48 lb-ft)
Installation
1. Check the rear axle shaft.
2. Insert the rear axle shaft into the axle housing and
tighten the fixing nuts of axle shaft flange.
Installation Notice
3. Connect the brake cable and install the brake
drum.
4. Install the tire and test the braking force.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст