Nissan Pathfinder. Manual — part 385
DLK-306
< REMOVAL AND INSTALLATION >
REAR DOOR LOCK
2. Remove inside handle screw (A) and inside handle (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• After installation, check door lock cables are properly engaged to inside handle.
• After installation, check door open/close and lock/unlock operation.
OUTSIDE HANDLE
OUTSIDE HANDLE : Removal and Installation
INFOID:0000000009175900
REMOVAL
1. Fully close rear door glass.
2. Remove rear door finisher. Refer to
INT-17, "Removal and Installation"
3. Remove rear door vapor barrier.
NOTE:
Cut the butyl tape so that some parts of the butyl tape remain on the vapor barrier, if the vapor barrier is
reused.
4. Remove door side grommet and bolt from grommet hole.
5. While pulling (1) outside handle, remove (2) outside handle
escutcheon.
ALKIA2715ZZ
JMKIA0025ZZ
JMKIA5342ZZ
REAR DOOR LOCK
DLK-307
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
6. While pulling outside handle (1), slide toward rear of vehicle to
remove outside handle.
7. Remove front gasket and rear gasket.
8. Slide outside handle bracket toward rear of vehicle to remove.
9. Disconnect outside handle cable (1) from outside handle bracket
(2) as shown.
INSTALLATION
Installation in the reverse order of removal.
CAUTION:
• After installation, check door lock cable is properly engaged to outside handle bracket.
• After installation, check door open/close and lock/unlock operation.
AWKIA1997ZZ
JMKIA2652ZZ
ALKIA2489ZZ
DLK-308
< REMOVAL AND INSTALLATION >
BACK DOOR LOCK
BACK DOOR LOCK
Exploded View
INFOID:0000000009175901
DOOR LOCK
DOOR LOCK : Removal and Installation
INFOID:0000000009175902
REMOVAL
1. Remove back door lower finisher. Refer to
INT-35, "BACK DOOR LOWER FINISHER : Removal and
.
2. Disconnect harness connector (B) from the back door lock (2).
3. Remove back door lock bolts (A) and back door lock (2) from
back door assembly (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check back door open/close and lock/unlock operation.
TOUCH SENSOR
1.
Door striker
2.
Automatic back door control module
(if equipped)
3.
Back door lock
4.
Back door panel
AWKIA2617ZZ
AWKIA2631ZZ
BACK DOOR LOCK
DLK-309
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
TOUCH SENSOR : Removal and Installation
INFOID:0000000009175903
CAUTION:
Use care not to bend touch sensor.
REMOVAL
1. Remove back door side finishers. Refer to
INT-35, "BACK DOOR SIDE FINISHER : Removal and Installa-
2. Disconnect the harness connectors from the touch sensor.
3. Release clips and remove screws that retain touch sensor.
4. Remove touch sensor harness from the back door assembly, then remove touch sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check back door open/close and lock/unlock operation.
EMERGENCY LEVER
EMERGENCY LEVER : Unlock procedures
INFOID:0000000009175904
UNLOCK PROCEDURES
NOTE:
If back door lock cannot be unlocked due to a malfunction or battery discharge, perform the following proce-
dures to unlock back door assembly.
1. Remove the emergency handle mask, using a suitable tool to release.
2. From inside the vehicle, rotate emergency lever in the direction
shown to unlock.
JMKIA5264ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст