Suzuki Grand Vitara JB627. Manual — part 287
7B-64 Air Conditioning System:
3) Remove front bumper assembly referring to “Front
Bumper Components in Section 9K”.
4) Remove front bumper upper member referring to
“Front Bumper Components in Section 9K”.
5) Disconnect compressor discharge hose (1) and
liquid pipe (2) from condenser assembly (4).
CAUTION
!
As soon as above hose and pipe are
disconnected, cap opened fittings so that
moisture and dust do not enter condenser.
6) Remove condenser assembly mounting bolts (3),
and then remove condenser assembly.
NOTE
Be careful not to damage fins of condenser
and radiator.
Installation
Reverse removal sequence to install condenser, noting
the following point.
• Replenish specified amount of compressor oil to
compressor suction side referring to “Precautions on
Replenishing Compressor Oil”.
• Evacuate and charge the A/C system referring to
“Evacuation” and “Charge” in “Operation Procedure
for Charging A/C with Refrigerant”.
Desiccant Removal and Installation
S6JB0B7206004
Removal
1) Remove condenser assembly from vehicle referring
to “A/C Condenser Assembly Removal and
Installation”.
2) Remove circlip (4) using special tool.
Special tool
: 09900–06107
3) Remove the filter (1) from the receiver / dryer tank
(2).
4) Remove desiccant (3).
Installation
Reverse removal sequence to install desiccant,
according to instruction manual with supply parts.
NOTE
• Replenish specified amount of compressor
oil to compressor suction side referring to
“Precautions on Replenishing Compressor
Oil”.
• Install circlip (1) as shown in figure.
3
3
1
2
4
I5JB0A720036-02
3
2
1
4
I5JB0A720037-02
1
I5JB0A720038-01
Air Conditioning System: 7B-65
HVAC Air Filter Removal and Installation
S6JB0B7206005
Removal
1) Disconnect negative (–) cable at battery.
2) Remove glove box.
3) Remove filter cover (1).
4) Pull out filter element (1).
Installation
Reverse removal procedure for installation noting the
followings:
• Install filter (1) into blower unit by paying attention to
direction of arrow on filter.
• Enable air bag system after installation of filter.
Refer to “Enabling Air Bag System in Section 8B”.
HVAC Air Filter Inspection
S6JB0B7206006
Check that filter is not excessively dirty, damage or oily,
clean filter with compressed air from air outlet side of
filter. If abnormality is found, replace filter with new one.
1
I5JB0A720039-01
1
I5JB0A720040-03
1
I5JB0A720041-03
I5JB0A720092-02
7B-66 Air Conditioning System:
HVAC Unit Components
S6JB0B7206007
20
19
21
25
16
17
22
22
18
3
2
1
5
23
24
16
15
26
26
26
27
26
4
6
14
1
7
9
13
12
10
8
11
[A]
I6JB0B720001-01
Air Conditioning System: 7B-67
26
27
26
1
3
3
2
4
5
6
[B]
24
23
22
22
20
19
1
10
11
12
13
15
9
8
21
25
14
16
16
18
17
7
I6JB0B720002-01
[A]: LHD model
9. Evaporator temperature sensor
19. Temperature control links
[B]: RHD model
10. Blower lower case
20. Temperature control actuator
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст