Toyota Tundra. Manual — part 723
Fig. 30: Identifying O5 Rear Switch RH Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to Next Step
2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
a. Remove the switch (see REMOVAL ).
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE TESTER CONNECTION SPECIFIED CONDITION
Tester Connection Switch Condition Specified Condition
4 (U) - 3 (B)
UP
Below 1 ohms
1 (D) - 2 (SD)
4 (U) - 5 (SU)
OFF
Below 1 ohms
1 (D) - 2 (SD)
4 (U) - S (SU)
DOWN
Below 1 ohms
1 (D) - 3 (B)
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Windshield/WindowGlass - Tundra
Fig. 31: Identifying Rear Power Window Regulator Switch Assembly RH Connector
Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH (see
REMOVAL )
OK: Go to Next Step
3. CHECK HARNESS AND CONNECTOR (REAR SWITCH RH - REAR MOTOR RH)
Fig. 32: Identifying O5 Rear Switch RH And O3 Rear Motor RH Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a. Disconnect the O5 switch connector.
b. Disconnect the O3 motor connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Windshield/WindowGlass - Tundra
for Double Cab:
REAR SWITCH RH - REAR MOTOR RH (FOR DOUBLE CAB)
for CrewMax:
REAR SWITCH RH - REAR MOTOR RH (FOR CREWMAX)
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to Next Step
4. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
a. Remove the motor (see REMOVAL ).
b. Apply battery voltage to connector terminals 1 and 2.
c. Check that the motor gear rotates smoothly as follows.
OK
MOTOR GEAR MEASUREMENT SPECIFIED CONDITION
Tester Connection
Condition Specified Condition
O5-1 (D) - O3-2
Always
Below 1 ohms
O5-4 (U) - O3-1
O5-1 (D) or O3-2 - Body ground
Always
10 kohms or higher
O5-4 (U) or O3-1 - Body ground
Tester Connection
Condition Specified Condition
O5-1 (D) - O3-1
Always
Below 1 ohms
O5-4 (U) - O3-2
O5-1 (D) or O3-1 - Body ground
Always
10 kohms or higher
O5-4 (U) or O3-2 - Body ground
Measurement Condition
Specified Condition
Battery positive (+) --> 1
Battery negative (-) --> 2
Motor gear rotates clockwise
Battery positive (+) --> 2
Battery negative (-) --> 1
Motor gear rotates counterclockwise
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Windshield/WindowGlass - Tundra
Fig. 33: Identifying Rear Power Window Regulator Motor Assembly RH Connector
Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (see
REMOVAL )
OK: Go to Next Step
5. CHECK HARNESS AND CONNECTOR (MASTER SWITCH - REAR SWITCH RH)
Fig. 34: Identifying N2 Master Switch And O5 Rear Switch RH Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Windshield/WindowGlass - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст