Toyota Tundra. Manual — part 835
Fig. 75: Identifying Fog Light Connector Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Install the front fender splash shield with the 2 screws, clip and 2 new clips labeled A.
Fig. 76: Identifying Front Fender Splash Shield With Screws And Clip
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
16. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Fog Light)
HINT:
Use the same procedures described for the LH side.
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
REAR BUMPER (FOR RESIN TYPE BUMPER)
COMPONENTS
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Exterior - Tundra
Fig. 77: Identifying Rear Bumper Replacement Components With Torque Specifications - For Resin
Type Bumper (1 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Exterior - Tundra
Fig. 78: Identifying Rear Bumper Replacement Components With Torque Specifications - For Resin
Type Bumper (2 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Exterior - Tundra
Fig. 79: Identifying Rear Bumper Replacement Components - For Resin Type Bumper (3 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Exterior - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст