Toyota Tundra. Manual — part 2016
Fig. 201: Locating Engine Hangers
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
b
Attach an engine sling device and hang the engine with a chain block
c
Remove the bolts and engine assembly from the engine stand
2
INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See INSTALLATION )
3
INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (See INSTALLATION )
4
INSTALL ENGINE ASSEMBLY
a
Slowly lower the engine assembly into the engine compartment
b
Attach the engine mounting insulators to the vehicle
c
Install the 4 engine mounting insulator bolts
Torque: 79 N*m (806 kgf*cm, 58 ft.*lbf)
Fig. 202: Locating Engine Mounting Insulator Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d
Remove the 2 bolts and 2 engine hangers
5
INSTALL NO. 1 WATER BY-PASS PIPE
a
Connect the hose and install the water by-pass pipe with the 2 bolts
Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
NOTE:
Make sure that the engine is clear of all wiring and hoses.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 203: Locating No. 1 Water By-Pass Pipe Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
6
INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
a
Using SST, hold the crankshaft
SST 09213-70011,09330-00021
Fig. 204: Holding Crankshaft
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Install the crankshaft angle sensor plate, drive gear and rear drive plate spacer to the crankshaft
c
Install and uniformly tighten 10 new bolts in the sequence shown in the illustration
Torque: 30 N*m (301 kgf*cm, 22 ft.*lbf)
NOTE:
Do not reuse the flywheel installation bolts.
Do not strike or damage the flywheel installation bolts. Be sure
to handle them carefully.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
d
Mark the upside of each flywheel installation bolt with paint
Fig. 205: Identifying Flywheel Bolts Tightening Sequence
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Fig. 206: Identifying Flywheel Installation Bolt Mark
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
e
Tighten the flywheel installation bolts another 90° as shown
f
Check that the painted marks are now at a 90° angle to the upside
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст