Toyota Tundra. Manual — part 2358
5
INSTALL INTAKE MANIFOLD ASSEMBLY
a
Install the intake manifold (see INSTALLATION )
6
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
STARTER RELAY
ON-VEHICLE INSPECTION
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2
REMOVE STARTER RELAY (ST)
a
Remove the engine room relay box cover
b
Remove the starter relay from the engine room relay block
3
INSPECT STARTER RELAY
a
Measure the resistance according to the value(s) in the table below
Standard resistance
STARTER RELAY
If the result is not as specified, replace the relay
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Terminal
Connection
Condition
Specified
Condition
3 - 5
When battery voltage is not applied to terminals 1 and
2
10 kohms or higher
When battery voltage is applied to terminals 1 and 2
Below 1 ohms
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 80: Inspecting Starter Relay
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4
INSTALL STARTER RELAY
5
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
ACC RELAY
ON-VEHICLE INSPECTION
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2
INSPECT MAIN BODY ECU (ACC RELAY)
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 81: Identifying Main Body ECU Connector Terminal (ACC Relay)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a
Measure the resistance of the ACC relay circuit
1
Measure the resistance according to the value(s) in the table below
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст