Toyota Tundra. Manual — part 2359
Standard resistance
MAIN BODY ECU (ACC RELAY)
If the result is not as specified, replace the main body ECU
3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ACC CUT RELAY
ON-VEHICLE INSPECTION
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2
REMOVE ACC CUT RELAY
a
Remove the clip
b
Detach the 2 clips and remove the cowl side trim board RH
c
Remove the relay
3
INSPECT ACC CUT RELAY
a
Measure the resistance according to the value(s) in the table below
Standard resistance
ACC CUT RELAY
Tester
Connection
Condition
Specified
Condition
DD47-DD8
When battery voltage is not applied between DD45
and DD62
10 kohms or
higher
When battery voltage is applied between DD45 and
DD62
Below 1 ohms
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Tester Connection
Condition
Specified Condition
3 - 4
When battery voltage is not applied to terminals 1 and 2
Below 1 ohms
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
If the result is not as specified, replace the relay
When battery voltage is applied to terminals 1 and 2
10 kohms or higher
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 82: Inspecting ACC Cut Relay
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4
INSTALL ACC CUT RELAY
a
Install the relay
b
Attach the 2 clips to install the cowl side trim board RH
c
Install the clip
5
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
IGNITION SWITCH
COMPONENTS
Fig. 83: Identifying Ignition Switch Replacement Components (1 Of 10)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 84: Identifying Ignition Switch Replacement Components With Torque Specifications (2 Of 10)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст