Toyota Tundra. Manual — part 428
Fig. 44: Meter Illumination Does Not Dim At Night - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
a. Check for DTCs (see DTC CHECK/CLEAR ).
Result
DTC RESULT REFERENCE
B: Go to CAN COMMUNICATION SYSTEM (See CAN COMMUNICATION SYSTEM )
A: Go to next step
2. READ VALUE OF TECHSTREAM (LIGHT CONTROL RHEOSTAT)
a. Operate the Techstream according to the display and select "DATA LIST" or "Data List" (see
DATA LIST / ACTIVE TEST ).
Techstream
Combination Meter:
Result
Proceed to
CAN communication system DTC is not output
A
CAN communication system DTC is output
B
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
TECHSTREAM COMBINATION METER SPECIFICATIONS
OK: Light brightness can be changed within specified range by manual operation.
NG: Go to step 3
OK: REPLACE COMBINATION METER ASSEMBLY (see REMOVAL )
3. INSPECT LIGHT CONTROL RHEOSTAT
Tester
Display
Measurement Item/Range
Normal Condition
Diagnostic
Note
TAIL Cancel
SW*
TAIL cancel switch
condition/ON or OFF
ON: TAIL cancel switch ON
OFF: TAIL cancel switch OFF
-
Rheostat
value
Light control rheostat switch
input/Min.: 0, Max.: 100
Light control rheostat switch is
Dark (0) --> Bright (100)
Unit: %
HINT:
*: w/ TAIL cancel switch
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Fig. 45: Light Control Rheostat Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a. Remove the light control rheostat (see REMOVAL ).
b. Measure the resistance according to the value(s) in the table below.
Standard resistance:
w/o TAIL Cancel Switch
RESISTANCE W/O TAIL CANCEL SWITCH REFERENCE
w/ TAIL Cancel Switch
Tester Connection
Switch Condition
Specified Condition
3 (RV) - 1 (E)
Downward --> Upward
See illustration
7(T) - 1 (E)
Downward --> Upward 10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
RESISTANCE W/ TAIL CANCEL SWITCH REFERENCE
NG: REPLACE LIGHT CONTROL RHEOSTAT (see REMOVAL )
OK: Go to next step
4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - LIGHT CONTROL
RHEOSTAT)
a. Disconnect the J28 meter connector.
Fig. 46: Identifying L4 Rheostat Connector Terminal J28 Meter Connector Terminal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Disconnect the L4 rheostat connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
3 (RV) - 1 (E)
Downward --> Upward
See Illustration
5 (TC) - 1 (E)
Downward --> Upward 10 kohms or higher
7 (T) - 1 (E)
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Meter - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст