Toyota Tundra (2015 year). Manual — part 863
Maximum bearing axial play:
0.05 mm (0.00197 in.)
PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD):...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002HBN00BX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): INSTALLATION; 2015 MY Tundra [08/2014
- ]
INSTALLATION
1. MEASURE TRANSFER AND DIFFERENTIAL FLANGE ANGLE
NOTICE:
Perform the inspection on a level surface.
Perform the inspection with the vehicle empty.
Perform the inspection with all wheels on the ground.
HINT:
As the transfer and rear differential flange angles are necessary when measuring the installation angle of
(A).
SST: 09370-50010
Text in Illustration
*a
Transfer Flange Angle: A
SST: 09370-50010
Text in Illustration
*a
Rear Differential Flange Angle: B
2. TEMPORARILY INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
HINT:
When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the
PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD):...
direction shown in the illustration.
Text in Illustration
*a
Grease Fitting
*b
View A
A
-
-
(b) w/o Bearing Washer:
(1) Temporarily install the center support bearing to the
crossmember with the 2 mounting bolts.
(c) w/ Bearing Washer:
PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD):...
(1) Temporarily install the center support bearing to the
crossmember with the 2 bearing washers and 2 mounting
bolts.
Text in Illustration
*1
No. 2 Center Support Bearing Washer
*2
No. 1 Center Support Bearing Assembly
*a
Frame
(d) Align the matchmarks on the flange yoke and transfer flange.
Text in Illustration
*a
for Transfer Side
*b
Matchmark
(e) Install the propeller shaft to the transfer side with the 4 nuts.
Torque:
70 N·m {714 kgf·cm, 52ft·lbf}
(f) Align the matchmarks on the flange yoke and differential flange.
Text in Illustration
*a
for Differential Side
*b
Matchmark
(g) Install the propeller shaft to the differential side with the 4 bolts and 4 nuts.
Torque:
70 N·m {714 kgf·cm, 52ft·lbf}
3. TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a) With the vehicle empty and all 4 tires supported by a lift, or with the vehicle suspension in the full rebound
PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD):...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст