Ford Galaxy / Ford S-MAX. Manual — part 248
8. Torque: 24 Nm
9. Torque: 25 Nm
10. Install the starter motor.
Refer to:
Starter Motor
(303-06D Starting System - 1.8L Duratorq
(92kW/125PS) - Lynx, Removal and Installation).
11.
WARNING: Make sure that the engine and transmission assembly is on wooden blocks and secured with
suitable retaining straps.
Secure the engine and transaxle assembly on a suitable workshop table and position it under the vehicle.
General Equipment:
Vehicle/axle stands
General Equipment:
Cable ties
12. Loosen: 2 turn(s)
13. Torque: 133 Nm
14.
1. Torque: 12 Nm
2. Torque: 80 Nm
3.
NOTE: Only tighten the bolts finger tight at this stage.
15. Raise the vehicle and remove the Vehicle/axle stands.
General Equipment:
Vehicle/axle stands
16. Torque: 80 Nm
17. Torque: 90 Nm
18. Connect the fuel supply line and fuel return line quick release couplings.
Refer to:
Fuel Filter
(310-01B Fuel Tank and Lines - 1.8L Duratorq
(92kW/125PS) - Lynx, Removal and Installation).
19. Connect the PCM electrical connectors.
Refer to:
Powertrain Control Module (PCM)
(303-14E Electronic Engine Controls
Lynx/1.8L Duratorq-TDCi (92kW/125PS) - Lynx, Removal and Installation).
20. Torque: 25 Nm
21. Torque: 23 Nm
22.
23.
CAUTION: Twisting the exhaust flexible pipe more than 2 degrees may cause damage resulting in failure.
Tighten all retaining nuts in the sequence shown.
Torque:
1-5: 25 Nm
6: 51 Nm
24. Remove the front subframe.
Refer to:
Front Subframe
(502-00 Uni-Body, Subframe and Mounting System, Removal and Installation).
25. Install the left-hand halfshaft.
Refer to:
Front Halfshaft LH
(205-04 Front Drive Halfshafts, Removal and Installation).
26. Install the right-hand halfshaft.
Refer to:
Front Halfshaft RH
(205-04 Front Drive Halfshafts, Removal and Installation).
27. Install both front wheels.
Refer to:
Wheel and Tire
(204-04 Wheels and Tires, Removal and Installation).
28. Torque: 23 Nm
29. Torque: 24 Nm
30.
31.
CAUTION: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with
cold water.
Bleed the clutch system.
Refer to: Clutch System Bleeding (308-00, General Procedures).
32.
CAUTION: Gearshift cables must not be kinked or bent.
Install the gearshift cables.
33. Adjust the gearshift cables.
Refer to:
Gearshift Cable Adjustment - Vehicles With: 6
Transmission/Transaxle and Clutch - General Information, General Procedures).
34.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст