Ford Ranger EV (2001 year). Manual — part 191
414-03B-160
414-03B-160
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
6. Disconnect the low-voltage connector.
1 Loosen the bolts.
2 Disconnect the connectors.
7. Remove the battery control module (BCM).
1 Remove the bolts.
2 Remove the BCM.
8. Position the IOM.
1 Remove the bolts.
2 Position the IOM aside.
9. Unclip the sense lead and relay from the
BCM/IOM bracket.
414-03B-161
414-03B-161
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
10. Remove the BCM/IOM bracket.
1 Remove the 4-pin auxiliary connector
bracket bolt.
2 Remove the bracket mounting bolts.
3 Remove the bracket.
11. Disconnect the harness connectors.
1 Disconnect the sense lead connectors.
2 Unclip and disconnect the thermistor.
12. Remove the low and high-voltage harness push
pins and fold the harnesses back over the rear
of the traction battery.
13. Unclip the battery hold down tie bar cover.
414-03B-162
414-03B-162
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
14. Remove the battery hold down strap bolt and
pull the straps back off the battery hold down
tie bar.
15. Remove the battery hold down tie bar.
16. NOTE: If removing module 18, disconnect the
two thermistor electrical connectors.
Disconnect the necessary module.
•
Disconnect the HVJ cables and discard the
nuts.
17. Using the special tool, remove the module.
414-03B-163
414-03B-163
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Installation
1. NOTE: The arrow on the battery hold down tie
bars must be pointed towards the front of the
traction battery.
To install, reverse the removal procedure.
•
Fill the high-voltage jumper connectors with
Nyogel after final tightening of the nuts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст