Ford Falcon. Manual — part 405
501-03-3 Body
Closures 501-03-3
REMOVAL AND INSTALLATION (Continued)
Weatherstrip Front and Rear Doors
Rear Door
Removal
Front Door
NOTE: The weatherstrips are attached to the doors
via a retaining channel above beltline and by push fit
fasteners below beltline.
Above Beltline
1. Remove at corner cup, pull w/strip to remove from
door retainer recess.
Below Beltline
1. Grasp the weatherstrip beside fastener and pull,
stretch and lift the weatherstrip to detach it from
the end of the fastener. Slide the weatherstrip in
the opposite direction to disengage from the other
end of the fastener.
2. Using a pair of pliers firmly grasp the fastener and
pull from the door panel. Fasteners must be
renewed after removal.
Installation
Above Beltline
1. Affix top corner clip and first clip on A-and B-pillar.
2. Sit lower edge of weatherstrip base in to retainer
and then, push upper edge of base into retainer.
Below Beltline
1. Assemble the fasteners to the weatherstrip and
install to the door panel. Ensure the fasteners are
fully seated.
G80840 en
501-03-4 Body
Closures 501-03-4
REMOVAL AND INSTALLATION (Continued)
Decklid Weatherstrip
Liftgate Weatherstrip
Removal
Removal
1. Remove Decklid Weatherstrip as shown in figure. 1. Remove liftgate weatherstrip as shown in figure.
Installation
1. Reverse removal procedure.
NOTE: Vulcanised joint to be on centre line.
Yellow dot signifies centre line near latch.
A rubber moller may be used to assist installation.
Roof Side Rail - Sedan
Removal
1. Remove flange from fitting along complete length,
except
…
2. At sequence Z, unclip flange.
3. At sequence Y, remove adhesive from ditch
moulding on underside edge of top of
weatherstrip.
Installation
1. Reverse
removal
procedure
NOTE: The weatherstrip must be positioned with
the trim panel lip on the inboard side of the body
flange and covering the trim panel. Vulcanised
joint to be on centre line near latch. Fully insert
the weatherstrip onto the flange.
A rubber moller may be used to assist installation.
G80840 en
501-03-5 Body
Closures 501-03-5
REMOVAL AND INSTALLATION (Continued)
Installation
1. Reverse removal procedure.
G80844 en
501-03-6 Body
Closures 501-03-6
REMOVAL AND INSTALLATION (Continued)
2. At sequence Z, unclip flange.
Roof Side Rail — Wagon
3. At sequence Y, align weatherstrip to corner.
Removal
1. Remove flange from fitting along complete length,
except
…
Installation
Installation
1. Reverse removal procedure.
1. Reverse removal procedure.
NOTE: Trim panel to be facing towards front of
Dash Panel Upper Seal
vehicle.
Removal
Hood Inner Seal
1. Remove dash panel weatherstrip as shown in
figure.
Removal
1. Remove hood inner weatherstrip as shown in
figure.
G80844 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст