Ford Falcon. Manual — part 297
310-02-12 Acceleration
Control 310-02-12
REMOVAL AND INSTALLATION (Continued)
2. Install the pivot pin to align the Carrier Plate and
6. Install the pivot pin.
APM unit.
7. Install the accelerator gearbox screws to the
3. Tighten the bolts / nuts to the Carrier Plate and
specified torque.
APM unit to the specified torque.
8. Install the pedal box to the car. Refer to pedal box
4. Remove the pivot pin.
installation in Section 206-06.
5. Install the accelerator pedal assembly by sliding
CAUTION: The adjustable pedal system
to the side and then rotating into position as
must be indexed whenever the brake pedal
shown.
assembly or the accelerator pedal assembly is
CAUTION: When installing the accelerator
serviced.
pedal assembly keep accelerator adjustment
Accelerator Pedal and APM unit —
gearbox and accelerator mechanism aligned at
all times.
Fixed Pedals
Removal
1. Remove pedal box from car. To remove pedal box
see Section 206-06.
G73256 en
310-02-13 Acceleration
Control 310-02-13
REMOVAL AND INSTALLATION (Continued)
2. Remove nut and bolt holding accelerator pedal
5. Remove bolts / nuts to separate the Carrier Plate
assembly to pedal box.
from the APM unit.
3. Remove pivot pin using flat head screwdriver.
Installation
1. Loosely reinstall the bolts / nuts to the Carrier
Plate and APM unit.
4. Remove accelerator pedal assembly.
2. Install the pivot pin to align the Carrier Plate and
APM unit.
G73257 en
310-02-14 Acceleration
Control 310-02-14
REMOVAL AND INSTALLATION (Continued)
3. Tighten the bolts / nuts to the Carrier Plate and
7. Install the accelerator pedal assembly to the pedal
APM unit to the specified torque.
box screw to the specified torque.
4. Remove the pivot pin.
8. Install the pedal box to the car. Refer to pedal box
installation in Section 206-06.
5. Install the accelerator pedal assembly by sliding
to the side and then rotating into position as
CAUTION: The adjustable pedal system
shown.
must be indexed whenever the brake pedal
assembly or the accelerator pedal assembly is
CAUTION: When installing the accelerator
serviced.
pedal assembly keep accelerator adjustment
gearbox and accelerator mechanism aligned at
Adjustable Pedal Indexing
all times.
Removal and Installation
CAUTION: The adjustable pedal system must
be indexed whenever the brake pedal assembly or
the accelerator pedal assembly is serviced.
CAUTION: If the fuse box is removed the
battery must be disconnected first.
NOTE: Access to the drive cable is made easier by
removing the fuse box.
1. Adjust pedals to approx mid position and
disconnect the adjustment cable.
6. Install the pivot pin.
G73257 en
310-02-15 Acceleration
Control 310-02-15
REMOVAL AND INSTALLATION (Continued)
2. Operate the switch until the accelerator pedal
5. Detach the drive cable from the brake pedal
reached its upper limit of travel.
assembly.
3. Connect the drive cable to the brake pedal
6. Operate the switch until the accelerator pedal is
assembly.
adjusted to its lower limit of travel.
4. Operate the switch until the brake pedal is in the
7. Adjust the accelerator pedal back 2- 3 mm.
stall position at the lower limit of travel.
G73258 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст