Ford Falcon. Manual — part 158
303-01c-53
Engine — V8 (4V)
303-01c-53
DISASSEMBLY (Continued)
2. Using the special tools, remove the rear oil
7. Install the lifting bracket special tools on the LH
slinger.
and RH sides of the engine.
NOTE: LH shown, RH similar.
3. Using the special tools, remove the rear main
seal.
8. Mount the engine on a work stand.
4. Lower the engine onto the wooden blocks.
9. Drain oil, remove filter.
Remove the bolts and the oil pan.
5. Remove the LH exhaust manifold.
Clean and inspect the sealing surfaces.
1. Remove the eight bolts.
2. Remove the manifold and discard the gasket.
CAUTION: Do not use metal scrapers,
6. Remove the stud and the oil level indicator and
wire brushes, power abrasive discs or
tube.
other abrasive means to clean the sealing
surfaces. These tools cause scratches and
gouges which make leak paths. Use a
plastic scraping tool to remove all traces
of old sealant.
G89796 en
303-01c-54
Engine — V8 (4V)
303-01c-54
DISASSEMBLY (Continued)
13. Remove the cylinder block drain plugs, and drain
10. Remove the bolts and the rear seal retainer plate.
the coolant in a suitable container.
Clean and inspect the sealing surfaces.
NOTE: LH shown, RH similar.
CAUTION: Do not use metal scrapers,
wire brushes, power abrasive discs or
other abrasive means to clean the sealing
surfaces. These tools cause scratches and
gouges which make leak paths. Use a
plastic scraping tool to remove all traces
of old sealant.
14. Disconnect the oil pressure sender.
11. Remove the special tools from the LH and RH
sides of the engine.
NOTE: LH shown, RH similar.
15. Remove the bolts and the LH ignition coil cover.
12. Remove the RH and LH engine mounts.
NOTE: LH shown, RH similar.
G89796 en
303-01c-55
Engine — V8 (4V)
303-01c-55
DISASSEMBLY (Continued)
16. Disconnect the ignition coils.
19. Remove the bolts and the RH ignition coil cover.
17. Remove the ignition coils.
20. Disconnect the ignition coils.
18. Disconnect the camshaft position (CMP) sensor.
21. Remove the ignition coils.
G89796 en
303-01c-56
Engine — V8 (4V)
303-01c-56
DISASSEMBLY (Continued)
22. Remove the heater return tube and heater supply 24. Remove the water pump pulley.
tubes.
1. Remove the bolts.
2.
Remove
the
pulley.
23. Remove the Heater supply tube.
25. Remove the water pump bolts.
G89796 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст