Ford Falcon. Manual — part 154
303-01c-37
Engine — V8 (4V)
303-01c-37
IN-VEHICLE REPAIR (Continued)
6. Compress the tensioner and install a lock pin.
7. Remove the timing chain, the sprocket, and intake
camshaft sprocket spacer.
10. Mark cach camshaft for identification purposes.
8. Remove the bolts.
NOTE: LH shown; RH similar.
9. Remove the bolts and the camshaft bearing cap
assemblies.
CAUTION: The outer bolts on the outer
cam bearing cap (exhaust) are longer and
must be returned to the same location or
engine damage may occur.
NOTE: Identify the camshaft to cylinder head
location. Caps are not interchangeable.
G89784 en
303-01c-38
Engine — V8 (4V)
303-01c-38
IN-VEHICLE REPAIR (Continued)
11. Remove the camshafts.
Installation
1. Install the camshafts.
CAUTION: It is vital for camshafts to be
marked before removal as each one is
Lubricate the camshafts with clean engine oil.
different and must be re-installed inti its
NOTE: LH shown; RH similar.
original position.
NOTE: Each camshaft has its part number
stamped on its shaft.
NOTE: All 4 camshafts are different.
G89784 en
303-01c-39
Engine — V8 (4V)
303-01c-39
IN-VEHICLE REPAIR (Continued)
4. Install the camshaft sprockets and the chain as an
2. Install the camshaft bearing cap assemblies.
assembly.
CAUTION: Timing marks must be at 12
o’clock and indexed at 6 o’clock.
5. Remove the lockpin from the chain tensioner.
6. Install the special tool.
3. Install the bolts.
G89784 en
303-01c-40
Engine — V8 (4V)
303-01c-40
IN-VEHICLE REPAIR (Continued)
7. Tighten the exhaust camshaft sprocket and the
2. Install engine in vehicle. For additional
intake camshaft bolt washer and spacer in two
information, refer to Engine Installation in this
stages:
section.
Stage 1: Tighten to 40 Nm (30 lb-ft).
Oil Filter Adapter
Tighten an additional 90 degrees.
Removal
1. Raise and support the vehicle. For additional
information, refer to Section 100-02.
2. Drain the cooling system. For additional
information, refer to Section 303-03.
3. Remove the oil filter.
8. Remove the special tool.
9. Install the left timing chain for the left side or both
timing chains for the right side. For additional
information, refer to Timing Drive Components in
this section.
10. Install the roller followers. For additional
information, refer to Roller Followers in this
4. Disconnect the oil pressure sensor.
section.
Exhaust Manifold — LH
Removal
NOTE: LH shown; RH similar.
1. Remove engine from vehicle. For additional
information, refer to removal of Engine in this
section.
2. Remove the exhaust manifold.
Remove the eight nuts.
Remove the exhaust manifold and discard
gasket.
Installation
5. Remove the oil pressure sender.
1. To install, reverse the removal procedure.
Install a new gasket.
G89784 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст