Chery B14. Manual — part 31
2.1.4 Disassemble connecting bolts between steering column
and cross beam by No. 10 socket spanner.
Installation torque is 25±3Nm
2.1.5 Disassemble 2 bolts below steering column by No. 10
socket spanner.
Installation torque is 25±3 Nm
2.1.6 Disassemble 3 screws between cross beam bracket and
evaporator by cross head screwdriver.
Installation torque is 1.5±0.5 Nm
2.1.7 Disassemble 4 fixing bolts between cross beam front
end and car body by No. 13 socket spanner.
Installation torque is 20±2 Nm
2.1.8 Disassemble two fixing nuts marked in right figure by
No.13 sleeve.
Installation torque is 20±2 Nm
2.1.9 Disassemble two fixing bolts between cross beam and left
side of car body.
Installation torque is 20±2 Nm
2.1.10 Disassemble one fixing bolt between cross beam and
front side of car body by No. 10 socket spanner.
Installation torque is 20±2 Nm
2.1.11 Disassemble two fixing bolts between cross beam and
lower side of car body.
Installation torque is 20±2 Nm
2.1.12 Disassemble two bolts and two nuts
between cross beam and right side of car body by No. 13 sleeve.
Installation torque is 20±2 Nm
2.1.13 Take off cross beam.
2.2 Assembly steps
The installing steps are reverse to those for removal.
Chapter Nine AC System
I. System Composition
Air adjustment and distributing system: HVAC air mixing and distributor part, inside/outside
circulation air inlet, air outlet, outside circulation air filter.
Control system: control panel assembly, micro motor, blower, speed regulating mode, high/low
voltage switch, AC temperature sensor.
Heating system: heating water tank, hot water pipe, and engine cooling water system.
Cooling system: compressor, condenser, reservoir dryer, expansion valve, evaporator and pipe.
II. Disassembly of evaporator assembly
1 Preparation
Tool: cross head screwdriver, carp pliers, socket spanner
Auxiliary material: refrigerant, antifreeze, sponge rubber strip
2 Disassembly steps
2.1 Recycling the refrigerant by refrigerant recycling machine
Note:
(1) Do not deal with the refrigerant at closed place or near flame.
(2) Do not splash the refrigerant into eyes and skin.
2.2 Disassemble instrument panel assembly and front cross beam.
Condenser
AC compressor
Evaporator assembly
AC control panel
Dry Bottle
Low pressure pipe assembly
High pressure pipe assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст