Chery B14. Manual — part 16
Chapter Two Disassembly and Assembly of Inner Trimming
Parts
I. Disassembly and assembly of seat belt
1 Preparation
Tool: flat head screwdriver, spanner
Parts: one time using snap clip
2 Note
Keep the seat belt clean and far away from oil, check it
for damage.
3 Disassembly steps(e.g. front seat belt)
3.1 Prize the front threshold pressing plate carefully
with flat head screwdriver.
3.2 Disassemble the front door weather strip.
3.3 Disassemble the rear door threshold pressing panel
3.4 Disassemble rear door opening weather strip
3.5 Disassemble the seat belt lower trim cover
3.6 Loose the fixing nut, take out B pillar lower
protecting panel. Installation torque is 50±5Nm
3.7 Prize seat belt adjuster trim cover by flat head
screwdriver and make sure do not damage the inside clip
3.8 Loose the fixing nut by No. 17 spanner and take
off the seat belt.
Installation torque is 50±5Nm
4 Assembly steps
The installing steps are reverse to those for removal.
Note:
4.1 Keep the seat belt clean and far away from oil, check
it is damaged or not.
4.2 The pillar protecting board should be matched closely
with body and not allowed to appear loosing; and the match
with roof and weather strip should be good.
4.3 The seat belt adjusting slide back plate should can be
adjusted flexible on B pillar, and it will not influence the
seat belt adjustment. Clearance with lower protecting board
should be less than 1mm;
4.4 Clearance between B pillar lower protecting panel
and front/rear threshold pressing plate should be less than
1mm;
II. Disassembly/assembly of seat
Tool: No.16 sleeve
1 Disassembly steps
1.1 Push the seat back by pulling the moving
handle under the left seat and expose the lower fixing bolt.
1.2 Disassemble these two fixing bolts by sleeve
under the seat.
1.3 Move the handle by spanner and push forward the
seat, expose these two fixing bolts on the back side.
1.4 Disassemble these two fixing bolts at the back of seat by
sleeve.
1.5 Take off the connector under seat and take away the seat.
2 Assembly steps
The installing steps are reverse to those for removal.
Installation torque is 25±3Nm
III. Disassembly and assembly of the Armrest Box and Sub
Instrument Panel
Tool: cross head screwdriver
1 Disassembly steps
1.1 Disassemble these 4 connection screw from armrest box and sub instrument panel by cross
head screwdriver(fasten torque is 2±0.5N.m)and take away the armrest.
1.2 Take away two bolts which connected between sub instrument panel and front lower
protecting board by cross head screwdriver (fasten torque is 2±0.5N.m),and take down the sub
instrument panel and 5 lower connecting plugs.
2 Assembly steps
The installing steps are reverse to those for removal.
IV. Disassembly and assembly of carpet
Tool: flat head screwdriver, cross head screwdriver; sleeve
1 Disassembly steps
1.1 Disassemble the seat (See disassembly of seat)
1.2 Disassemble threshold pressing plate, B pillar and C
pillar lower protecting board (See disassembly of B pillar
and C Pillar)
1.3 Disassemble A pillar lower trim panel
1.4 Disassemble armrest box and sub instrument panel (See
disassembly of armrest box and sub instrument panel)
1.5,Prize the cover on the driver pedal by flat head
screwdriver.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст