Chery A18. Manual — part 60
3.9. Take out the down shield of the B pillar
3.10. Loosen fixing bolts with the socket wrench 17#
and take out the safety belt
Moment:50±10N·m
4. Assembly steps
Assemble according to the inverted sequence of the disassembly
Attention:
4.1. Keep the safety belt clean, avoid being stained with
the oil and check whether the safety belt is spoiled or not;
4.2. The pillar shield fits with the carbody firmly, flexible
phenomenon is not allowed to start; and it should fit with
the roof, sealing strip well;
4.3.The safety belt adjusting slide way baffle plate of the
upper shield of the B pillar should move smoothly, not
affect the adjustment of the safety belt and the fit clearance
with the down shield is even and less than 1mm;
4.4. The fit clearance between the down shield of the B
pillar & the threshold pressing panel of the front and rear
II. Disassembly & assembly of the seat
Preparation tools: Ring wrench 10#, socket wrench 17#
and slotted screwdriver
1
.
Disassembly of front row seats
1.1. Make the seat move forward through pulling the
moving handle below the seat and uncover the fixing
bolts under the seat
1.2. Unscrew 1 fixing bolt after seats with the socket
wrench 17#
Moment:25±3N·m
1.3. Unscrew the limiting bolts of the slide way under
seats with the ring wrench 10#
1.4. Move back seats through pulling the moving
handle under seats and take out seats
2. Disassembly steps of middle row seats
2.1. Pull up the cushion of the rear row seat by hands
and separate the cushion from the buckle of the
chassis of carbody.
2.2. Unscrew 4 inner hexagonal bolts shown as the
figure with the inner hexagon spanner and take out the
cushion of the middle row seat
Moment:2.5±0.5N·m
2.3. Pull out the left side backrest of the middle row
seat and move forward a little
2.4. Move the left side backrest of the middle row seat
to the middle and take out the left side backrest of the
middle row seat
2.5. Prize up the rotary clip of the backrest with the
slotted screwdriver and take out the left side backrest
of the middle row seat with the same way
3. Disassembly steps of the back row seat
3.1. Pull back the pull rod under the rear row seat, pull
up the rear row seat at the same time and may separate
the rear row seat from the slot
3.2. Make the rear row seat be in the attitude shown as
the figure, and pull back the rear row seat to take out the
rear row seat
4. Assembly steps
4.1. Align 2 front slots to make the rear row seat be in
the attitude shown as the figure
4.2. Put down the seat with a little bit force, make 2
rear slots held well and complete the assembly of the
rear row seat.
III. Disassembly & assembly of the console
Preparation tool: Phillips screwdriver
1. Disassembly steps
1.1. Draw out the front ash tray, press the spring leaf in
the center of the ash tray with the hand and take out the
rear Ash tray
.
1.2. Unscrew 2 bolts connecting the console with the
instrumental panel with the Phillips screwdriver.
Moment: 3±0.5N.m
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст