Chery A18. Manual — part 59
6.1.2. Take out the rear handle
6.2. Assembly steps
Assemble according to the inverted sequence of the
disassembly
7. Disassembly of the license plate lamp
Tool: Phillips screwdriver
7.1. Disassembly steps
7.1.1. Take out the connector of the left & right license plate
lamps
7.1.2. Align the bolts of the license plate with the Phillips
screwdriver, unscrew them and there are 4 bolts in all.
7.2. Assembly steps
Assemble according to the inverted sequence of the disassembly
Chapter
Disassembly & Assembly of the Internal Trim
Ⅱ
Parts
I. Disassembly & assembly of the safety belt
1. Preparation
Tools: Slotted screwdriver, wrench and socket wrench
Parts: one-time buckle
2. Attention
Keep the safety belt clean, avoid being stained with the
oil and check whether the safety belt is spoiled or not
3. Disassembly steps (e.g. driver’s safety belt)
3.1. Prize up the protective cover of the bolts above the
safety belt with the slotted screwdriver
3.2. Unscrew fixing bolts above the safety belt with the
socket wrench 17#
Moment:50±10N·m
3.3. Carefully prize the protective cover of bolts below
the safety belt with the slotted screwdriver
3.4. Unscrew fixing bolts below the safety belt with the
socket wrench 17#
Moment: 50±10N·m
3.5. Partially disassemble the rubber strip at the driver’s
side door
3.6. Prize up the upper shield of the B pillar with the
slotted screwdriver
3.7. Prize up the pressing panel of the threshold with the
slotted screwdriver
Attention: The inside is fixed by the clip.
3.8. Unscrew 3 fixing bolts of the down shield of the B
pillar with the slotted screwdriver
Moment: 3±0.5Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст