Chery A18. Manual — part 58
7.1.4. Take out 2 buckles which can fix the back guy
with the Phillips screwdriver
7.1.5. Take out the back guy from the closure which is
from the front compartment through the car
7.1.6. Pull out the back guy
7.2. Assembly steps
Assemble according to the inverted sequence of the disassembly
Attention: When assembling, embed the slot of the back guy into the kerf
II. Disassembly of the rear door
1. Preparation
Tools: Phillips screwdriver, ring wrench 13#, socket wrench 10#, connecting
rod, ratchet wrench, flat-end screwdriver
2. Disassembly of the rear cover trim panel
2.1. Disassembly steps
2.1.1. Just take out the buck one by one of the internal
trim panel of the rear door
2.2. Assembly steps
Assemble according to the inverted sequence of the
disassembly
3. Disassembly & assembly of the knob lock of the rear door
3.1. Disassembly steps
Tool: Flat-end screwdriver
3.1.1. Take 2 pull rods connecting with the lock of the
rear door
3.1.2. Unscrew 3 position-fixing bolts of the knob lock
with the Ring wrench 8#, and then may take out the
lock. (Assembly Moment is 9±1Nm)
3.2. Assembly steps
Assemble according to the inverted sequence of the
disassembly
4. Disassembly of the lock core of the rear door
Preparation tool: Flat-end screwdriver
4.1. Disassembly steps
4.1.1. Separate the lock core with the connecting rod
4.1.2. Prize up the positioning clip with the flat-end
screwdriver, take it out and then just take out the lock core
Attention: Do not throw the washer of the lock core
4.2. Assembly steps
Assemble according to the inverted sequence of the
disassembly
Pay attention to right assembly which is completely jointed
with the plate work of the car door.
5. Disassembly of the trim of the license plate lamp
Tool: Ring wrench 10#
5.1. Disassembly steps
5.1.1. Unscrew 2 bolts of the trim panel with ring wrench 10#
5.1.2. Take out the trim panel
5.2. Assembly steps
Assemble according to the inverted sequence of the
disassembly(Assembly moment: 10±1Nm)
6. Disassembly of the rear door handle
Tool: Ring wrench 10#
6.1 Disassembly steps
6.1.1. Disassemble the pull rod of the handle, and then
unscrew 2 positioning bolts of the handle with the tool.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст